kaibart

Forum Replies Created

Viewing 15 posts - 811 through 825 (of 1,334 total)
  • Author
    Posts
  • kaibart
    Moderator

    Re: Beko WDA 91440W "safety" message displays and turns off

    I would check some of the beko wash dryers washers come with a 10 year warranty on motor just a thought

    in reply to: Senor meile dyer #455986
    kaibart
    Moderator

    Re: Senor meile dyer

    Unfortunately I had to ber the appliance as the customer wouldn’t pay over £80.00 for repair the brushes on top where shot. I think he is going to buy a cheap dryer 🙁 did advise but no telling some customers

    in reply to: Buying appliances to resell #456061
    kaibart
    Moderator

    Re: Buying appliances to resell

    Try john pye auctions if there’s 1 near you you can buy some decent stuff and make a profit on them if you buy the right machines

    in reply to: Senor meile dyer #455979
    kaibart
    Moderator

    Re: Senor meile dyer

    So been back to this dryer this morning and the sensor on the element ntc and thermostat are all ok 90kohms on ntc and 0.50hms on thermostat front sensor in front duct also reads ok is this a possible relay board for the heater?

    in reply to: Bosch WAN24000GB/01 taking too long #456047
    kaibart
    Moderator

    Re: Bosch WAN24000GB/01 taking too long

    I would check the element

    in reply to: Zanussi ZKG7145 914604048/01 washer dryer #456024
    kaibart
    Moderator

    Re: Zanussi ZKG7145 914604048/01 washer dryer

    Try disconnecting the dryer element then run it these give loads of weird faults

    in reply to: Senor meile dyer #455978
    kaibart
    Moderator
    in reply to: LG F1443KD6 11kg not spinning. #454879
    kaibart
    Moderator

    Re: LG F1443KD6 11kg not spinning.

    I’ve had 1 where the splines on the motor the part where the magnets are fitted to have worn away and cause this problem but I would replace rotor and stator the complete motor

    in reply to: Hoover OPHS 712B #455913
    kaibart
    Moderator

    Re: Hoover OPHS 712B

    The pcbs on these machine are responsible price so worth a shot

    in reply to: Meile dryer #455910
    kaibart
    Moderator

    Re: Meile dryer

    The carbons are worn out so I thought it would work where should I look then temperature sensor?

    in reply to: Meile dryer #455908
    kaibart
    Moderator

    Re: Meile dryer

    in reply to: Candy Grando Vita keeps stopping mid cycle #455783
    kaibart
    Moderator

    Re: Candy Grando Vita keeps stopping mid cycle

    The pump and housing are in the photo attached the 2 holes are where the pipes attach to it check them

    in reply to: Candy Grando Vita keeps stopping mid cycle #455781
    kaibart
    Moderator

    Re: Candy Grando Vita keeps stopping mid cycle

    There is something blocked the pump and housing are held on with 2 7mm screws from underneath so if you tilt the machine at 45 degrees on the worktop the pump will be easy to remove

    in reply to: Candy Grando Vita keeps stopping mid cycle #455778
    kaibart
    Moderator

    Re: Candy Grando Vita keeps stopping mid cycle

    1st thing to do is check the filter at the bottom corner make sure machine is unplugged and you have towels to hand if you don’t find d anything in the filter check the pump housing the plastic thing that the filter goes into as the pipes that connect onto it can get blocked with coins

    in reply to: Hoover Dynamic e08 #455705
    kaibart
    Moderator

    Re: Hoover Dynamic e08

    E08 is a motor related fault you say machine doesn’t spin on a wash cycle if the machine spins fine with a load in on spin only programme it will be a load issuse

Viewing 15 posts - 811 through 825 (of 1,334 total)