Forum Replies Created
-
Posts
-
Re: Bosch washer dryer – loud noise during drying cycle
If the noise is happening on the dry cycle and you can hear the noise coming from the fan motor that is more than likely the problem or it maybe something restricting the fan and causing it to make a noise that’s where to start make sure you unplug before working on appliance thou.
Re: Rangemaster Elise 100 Induction.
Water gets onto the potentiometer there is a mod for it I think but you would need to get hold of rangemaster technical these are easy to work on 2 screws at the side and the top lifts off
Re: Beko/DAG
All dag work on beko appliances is going through beko direct who then will filter the work out to it’s agents ( who repair under 1st year warranty) this is slowly coming into affect and will be totally up and running by june that’s what I know
Re: Logik LFSTC50W oven. Noticable Burning Smell
I would be looking at the terminal block where the mains cable should be 6mm twin and earth enters the cooker
Re: Candy GC 1682 D2 not dead but lifeless
Just to give you an idea of why you had burnt tracks on the rectifier pcb and damage to the main pcb is overloading if there is to much weight on the programme selected it puts more ware on the motor it self, hopefully your repair will work when I had this problem when I was working for Hoover candy I was told to change the motor rectifier pcb and main pcb.
Re: Candy 14104L door not locking
Try a motor on it or if it’s a China built machine change the brushes had a candy washer doing this a week or so ago and changed brushes and a way to go
Re: Samsung DW-FG720S dishwasher
Check drain pump for blockages if the pump blocks it wount heat it’s also got a heater and wash pump fitted all in 1
Re: candy gov580c
More than likely pcb you can check resistance on front ntc from the pcb to confirm pcb fault
Re: candy cdp95380pr-80
Yes if you call it the fill chamber that is what the fault ef is related to and I’ve change 1 or 2
Re: Candy GV 168T3W/1-80 display panel not working
There is a pcb in the back left hand corner as you look at it from the back that is at fault and need changing
Re: John Lewis d/w
Yes when it went on to 1st rinse that when it leaked I got all the suds out by rubing soap in the inner door until I only had clear water after filling and emptying it 5 or 6 times
Re: Customer refusing to pay up despite agreement
When you have been in the trade over 5 year plus you get to know if a customer is going to pay or not when the say something like it’s tripping the electrics how much will that be? You get that feeling waste of time job especially when you try and explain it could be anything
Re: John Lewis d/w
Been back to this dishwasher today and I thought I nailed the fault when a seen it over suddin as customer using all in 1 tablets and rinse aid so flushed out all the suds test ok told customer to run machine empty and give me a ring and lone and behold it’s still leaking this is only a month away from running out of warranty. I checked door was fine checked lower spray arm and that’s ok to, where do I go from here any ideas yes I’m doing this for manufacturer Tia Kai
