[kaibart]

Re: Senor meile dyer

That’s what I’ve been running it on I think it a air flow issue when I took out the condenser and 2 door filters it didn’t stop it ran through the 30 mins timed dry

[kaibart]

Re: Senor meile dyer

So I’ve picked this dryer up off customer and I’ve got correct readings on front door ntc rear ntc and thermostat on heater and check all wiring to heater relay pcb I’ve another meile dryer with a relay pcb but it only has 3 relays on it and is still the same any ideas?

[kaibart]

Re: sealed tub

The guys a tool if he thinks that repair will last

[kaibart]

Re: Range Master 110 dual fuel cooker

Yes the control panel is easy to change remove control knobs and the timer buttons and there’s a few screws which need to come out

[kaibart]

Re: Hoover VHD Washer flashing "Timer Saver + 1200 spin"

Definitely check brushes that machine is over 10 years old now very reliable unit they where

[kaibart]

Re: Glass lid

This needs to be looked at by a gas safe engineer as the lid needs to come off

[kaibart]

Re: Cda/ white knight dryer

I’ve got resistance between the paddle and brush aswell what’s got me it’s something I’m overlooked somewhere but I can’t think what

[kaibart]

Re: Cda/ white knight dryer

I’ve changed the pcb heater resettable stat and exhaust stat and I have no power to the heater anybody any ideas

[kaibart]

Re: Samsung American

Thank you very much

[kaibart]

Re: Samsung American

Not systems trained so would rather change components I know where the air sensor is but where is the fuse?

[kaibart]

Re: Beko door

Il have to dig some out then just thought it would be easier to order the whole lot

[kaibart]

Re: Cda/ white knight dryer

Yes all checked I’m baffled

[kaibart]

Re: Beko WM74155

Sounds like the motor has failed then due to overloading

[kaibart]

Re: Beko WM74155

Worth checking the brushes and dc module top right corner if these are good then I would say pcb

[kaibart]

Re: Beko door

Cheers Dave can’t find position 885 though

[Author]

Posts