Forum Replies Created
-
Posts
-
Re: AEG 40010VI – 911935627/03 Dishwasher
Change both display and main modules get pre programmed 1s
Re: Hoover washing machine display frozen
If the door lock light comes on look at carbon brushes if they are fine what element part number did you fit? If these are both fine then it will be main pcb, Martin is trying to tell you to put the machine through a test cycle I don’t think that will make a difference
Re: User Fails
The best part is see phoned shop and said her cooker caught fire I wonder why only in Wales Skewen 😆 😆
Re: Zanussi oven dead
Did know if it had 1 Dave had pcn and serial number over the phone just wanted a heads up if there was a toc fitted and where it’s located cheer for tech info
Re: Rangemaster excel 110 g5 induction cooker
If I remember rightly when I done the rangemaster course on Induction I’m sure that it comes with a leaflet showing you how to programme the main power pcb if not I should have a number to rangemaster technical il have to dig it out
Re: Rangemaster excel 110 g5 induction cooker
Probably need 2 board main power pcb and slave pcb they will need to be programmed thou which is a headache
Re: Bosch WAS28461GB/07 stopping mid hot wash
1st thing to check with a multimeter is resistance on the heater and the ntc that sits in the heater I would guess 1 of these will be faulty definitely not a control board issue if machine works fine on 40 degrees wash
Re: hoovr dhl1492d3-80
Yes parts are available part number for out door frame 43012588 and part number for door lock 41041367 Kai
Re: Oven igniter won’t stop clicking – cannon 10750G
This is something that needs to be done by a gas safe engineer
Re: Senor meile dyer
I done a full strip down yesterday and cleaned out the fluff from everywhere I had front panel and both sides off and cleaned everywhere I will update when I reassemble
Re: Senor meile dyer
I’d pulled it out to clean it and put the dryer on and it worked I’ve already replaced the brushes so I think a full strip down is called for
