[maltheviking]

Re: Meile G641 dishwasher

philfish wrote:think they also have a reed switch on the side of the container
hth
phil

That must mean there’s a magnet on the float

[maltheviking]

Re: Meile G641 dishwasher

Cheers Clayside I will have a look 😉

[maltheviking]

Re: Hoover D/W HD98E Problems – With Timer Underneath

laurenceuk wrote:Hi,

This machine has a PCB in the control panel and a timer underneath –
never seen this type before.

The problem is that the machine starts ok – empties then fills and begins
the wash but the spraying stops after about 15secs. The machine is then
silent but will continue on through the prog doing everything except
spraying the water.

All the components work: recirc motor, drain pump, heater, inlet valve –
everything.

I am pretty sure that it is this timer that is causing the problem.

Can anyone confirm this?

Can anyone advise as to whether there is anyone who can repair or
exchange as they are very expensive – they come as a timer/PCB
combination?

EMW don`t do them.

Thanks

Laurence
Hi Laurence Did you nail the problem with this?

[maltheviking]

Re: Belling Cooker 492SS

Washman wrote:Hi

Have a look at 4belling.co.uk they have listed Glass:door-outer lower oven 492SS £104.99 delivery within 7 days.

Mike
Same website as Connect, with no photo 😥 £73.58 but they cant confirm it’s the one I want, bluddy automatons 👿

[maltheviking]

Re: Belling Cooker 492SS

BobHope wrote:Hi Malt

it might help you id your appliance if not its still a handy site to have

http://www.gdha.org.uk/

Bob.
Thanks Bob
I have nailed it down to three types, 082603405, 082603412 and 082603405. the trouble is that no wholesaler have photos of them and some of them are “specials” 😯 you would think they would get their act together, I have been looking for this part for nealy two weeks

[maltheviking]

Re: Belling Cooker 492SS

Washman wrote:Hi

There is a Belling model XOU492ss

Mike Yep I know but this one is just 492ss, tis a Creda at heart

[maltheviking]

Re: Is this kosher??

I think the contract is between you and whoever gives you the job, if that be the letting agent then thats who it is.
Are you member of FSB? if so it may be worth giving them a buzz

[maltheviking]

Re: hoover/candy int f/f fridge thermistor

I missed this one 😳 may I have it please sir :rolls:

[maltheviking]

Re: Zanussi DA 6142 No D/Washer

a1al wrote:I dont think it has an inline saftey stat

Have sent my email via PM many thanks

a1alBuilt in the heater.
sent you the goodies that I have 😉

[maltheviking]

Re: Bosch WTL6003gb (whiteknight)

BSH-MAN wrote:Soak the fan blade hub in wd40 to get the thing off.
It’s better if you stretch the belt prior to fitting as this makes quite a difference.
I fit the belt over the drum and motor pulley and then lift up the drum.
At this point I find copious amounts of swearing helpful.

I keep a new fan just in case, as you say the beggers seize on.
yes the swearing is well apparant.
Cant quite understand the mentality in fitting these stretch belts, far to much downward pressure on the bearings, same problem with the Indeshyt range. Motor shaft tends to rust if the machine is not used for a while and the belt sticks to it, snaps when started again.

[maltheviking]

Re: Zanussi DA 6142 No D/Washer

a1al wrote:Hi Everyone

Have been out to this D/Washer it completes cylce but does not heat water at all, heater tested ok (26 omhs) water level switch on heater circuit seems to be ok and tested for broken cables.

Anyone any ideas, or know of any common faults on this model

Prod No 911911007/01

Model DA6142

Thanks a1alAint got an in line safety stat. has it?
PM me with your email and il’l send you some goodies 😉

[maltheviking]

Re: Integrated son of a b****

clivejameson wrote:
‘Who sold you this, then?’

Cracking video 😆
Trouble is you end up biting your lip in most houses due to the modern craap that is out there 😯

[maltheviking]

Re: Hoover HD 98E Dishwasher

Penguin45 wrote:Sent you what I can find.

Chris.Got it 😉 may your new car never break down 🙂 , thanks Chris

[maltheviking]

Re: Integrated son of a b****

Had a real bummer a couple of weeks back. I got called in to repair a ceramic hob fitted in a marble worktop. First thing I noticed was that there was no clamps on the underside 😯 and that the hob had been sealed in with silicon.
My first assesment was the correct one although customer was a bit miffed, I advised her to get the kitchen people back to get it out as I was not willing to take the responsibilty. Told to give me a ring when it had been removed.
Got the phone call a week later advising me not to call back 😯
turned out the kitchen fitter managed to smash the ceramic top and the whole unit would have to be replaced :rotl: bet the new one won’t be siliconed in 😉

[maltheviking]

Re: Horse with no name?

Dales-Electronic wrote:Was it bought from B&Q ?

No, some kitchen co. in Scotland 😳

[Author]

Posts