Forum Replies Created
-
Posts
-
Re: No lights
The main PCB has gone phut probably. Time to take a closer look.
Don’t forget to disconnect it from the mains before you do! :zap:
Re: bosch classix dishwasher electrical fault
Bad idea. You can get a new filter from Bosch’s own website very swiftly. Leave messing with it until you have the correct replacement. A day or two with Marigolds won’t kill you whereas messing with the mains and buggering it up just might! 😉
Re: Bosch sl15k1b flooding the kitchen
The model number you gave cannot be recognised. Please provide the complete ENR number which is normally stamped on the door area adjacent the latch.
Re: bosch classix dishwasher electrical fault
The mains filter (adjacent the mains terminal block inside the dishwasher) has blown and needs replacing.
Re: Help with JLWD1408 E80 and going straight to drain cycle
Firstly you will need to check the earth resistance of both wash and dryer heaters. (E80 is loosely associated with a wash pump fault by the way) but overall a secondhand, been in storage under unknown conditions, moisture, damp, knocked from pillar to post and you got yourself a heap of trouble there and make no mistake.
I wish you well and hope you don’t injure or electrocute yourself and others in the process. 🙁
Re: True or false?
stratfordgirl wrote:so surely it is reasonable to discuss that issue on the same thread?
Very reasonable and closely connected no doubt but bugger all to do with whether
or not we should concern ourselves over the issue of the consumer unit and the integrity between it and the oven. Flex or cable? Portable or fixed? is, to my mind and that of the OP, not the question here.Answers on a postcard to……
Lee8
2 Smug Villas
Skillset City
Beentheredonethatshire.Re: Replacing AEG PNC 944 185 295 oven timer
I have no clue unfortunately. All I do know from the 100’s of ovens I’ve fixed over the years is that a timer unit such as you have either (and more usually) comes out from inside the control panel area. Or you have to remove the entire trim around the whole oven front to enable the glass control panels removal.
Re: Replacing AEG PNC 944 185 295 oven timer
That being the case then you’ll need to remove the front trim and glass control panel for access.
Re: Siemens Vented dryer IQ300 stops after 3mins filter ligh
The fault indicative of an NTC fault or an airflow restriction somewhere (fluff block in heater box or exhaust through the wall) causing the NTC to close the programme down.
I think it neither a fault with the heater or the board at this stage TBH.
