Forum Replies Created
-
Posts
-
Re: Can anyone advise how to replace drive belt on bosch cla
Remove the rear fan then thread belt around the drive shaft.
Re: Bosch dishwasher pcb
All the usual places? Did you not look directly on the Bosch spare parts website?
For your convenience click the link below….
Re: BOSCH SGI57M05GB complketes cycle , doesn’t empty
That being the case then a wire/connector block has probably got displaced. Time to check and double check all connections.
Re: BOSCH SGI57M05GB complketes cycle , doesn’t empty
The question I set was, did the pump operate normally PRIOR to the heater change?
Re: Problem with Bosch Classixx 1200 express
Probably the brushes are arcing? If so you could do serious damage if not checked. The brushes have to make a good clean contact with the commutator and the commutator has to be clear of excess carbon dust and each segment clean and smooth with no uneven surface or blackened areas.
Re: BOSCH SGI57M05GB complketes cycle , doesn’t empty
If the pump worked OK before the heater change then I would think a wire has come adrift?
Re: Zdi6053w. 911929016
As you know there was an official recall on some later models. Your machine is much older but uses a similar PCB where the heater terminals overheat.
Re: Advice needed
clockworkone wrote:Addressed invoice to him c/o golf club. Marked envelope ” overdue account”. Got payd within a week.
Great story! :tup:
