Forum Replies Created
-
Posts
-
Re: Bosch SGS4072GB/02 F/S Dishwasher No Water Problem
After first checking the inlet valve is in fact opening correctly to feed the water in!
Re: Bosch SGS4072GB/02 F/S Dishwasher No Water Problem
Mother, is what my iPad, decided was the word I wanted to put!
No IPad! The word I wanted to put was “then”
Lol
M
Re: Bosch SGS4072GB/02 F/S Dishwasher No Water Problem
Check out the jug impeller…the small round plastic part,that’s the first thing after the water feed valve… If that’s ok,mother check out the matrix..
Martin
Re: Servis M6006
Sounds like the combined thermostat is faulty.. …a simple push fitting, though I can’t recall it’s exact position but lower back or front of drum is usual location… Costs around £20
Martin
Re: Indesit W123 error code 2
Sorry I misread your post… Thought you had a problem with the “spin”. As for not rinsing I’d check your filter is clear..
Martin
Re: Indesit W123 error code 2
It could well be the brushes.. If you have a problem with the commutator of the motor. Then the brushes would wear down prematurely . I’d check them just in case.
.and also check your filter is clear of debris..
Martin
Re: adp 4400 4 flashing green light
That’s a drain pump fault I believe, check all your filters in base of machine thoroughly..then if its still th same check your waste pipe from the machine…
Martin
Re: Creda 1st Choicw, Model W1003 Faulty Door Switch?
Easy to fit. Remove metal band from around rubber seal, then gently pull seal away.. Then hand in behind interlock, whilst you undo it’s mounting screws…
then take a note of where the wires go, then replace with the new one and re assemble in reverse order…
Martin
Re: Creda 1st Choicw, Model W1003 Faulty Door Switch?
Check the door catch on inside of door, this should be sprung loaded and you should feel some restiance when you operate the door release handle. If this check out the it sounds like you need a new door interlock… Readily available from uk whitegoods..
Martin
