Forum Replies Created
-
Posts
-
Re: Indesit IDF125UK Dishwasher
Thanks, It says check filters but i have checked for blockages etc but cant find anything, I have found that the ins readings are down at around 5.86 but when the heater is taken out the equaition its jumps up to around 519, Could that be throwing the board out?
Re: bosch wfo2865gb/08
Done! (What a bloody job that is. lol) As you said previously – not too bad really just time consuming, Thanks for the advice guys.
Re: bosch wfo2865gb/08
a couple of the little holes in the drum are knackered – Very mis-shaped snagged and dented, they are pretruding, therefore catching everything put in the wash, I’ve tried poking them back down, it is better but its not good by any means
Re: beko DWD4310
its definately the circ pump, i’ve got the base off and can feel the circ pump vibrating whilst the noise is happening (i’ve also manually activated the anti flood and then the drain pump cuts in fine). Also when i say leaking i mean just a build up of gunk on the bottom of the housing not like a streaming leak.
Re: Bosch WFO2865GB/08
that was it sometimes shows 88:88 on the display and sometimes nothing at all.
Re: Zanussi ZDF221 D/W
Thanks Mate,
top stuff, It was half a lolly stick in the pump, when i checked it first time there wasnt anything there so must of been floating around for a while before jamming the pump up againRe: Zanussi ZDF221 D/W
By saying water in the base i meant in the m/c normally not the base underneath. sorry
Re: Hotpoint WD71
Thanks. It definately looks like it could be the top back spring has been catching, there also looks like a bit of scuffing on the RH inner side panel (if your facing the m/c) caused by the motor. Any idea what causes either of these?
Re: Smeg DWF1 014870600
No blockages in the matrix or any pipes unfortunately clive, the pressure switch i can see seems to connect into it at the matrix at the bottom towards the front of the m/c, is that the one were talking about?
