Forum Replies Created
-
Posts
-
Re: Bosch Logixx Automiatic SGS0902GB/04 Fault(s)
Stage 2 is to remove the left hand side panel (from the front) and have a look at the pressure chamber (where that pipe joins on) and strip and clean that.
Something like this:
Explain (gently) to the Senior Dishwasher Operative that it’s a dishwasher, not a waste disposal unit – the heavy stuff has got to go before you set it off.
Regards,
Pemguin45.Re: TECNIK SE6TIE1GB/17 Dishwasher ‘pumps’ when switched on
Flood protection operated – water in the base moulding will operate a float switch, which in turn runs the drain pump.
Pull the plug, drag it out, remove side panels and tip the machine over to drain the base. Try then running a programme and see if you can observe the leak.
Penguin45.
Re: Whirlpool ADG 957 door won’t close.
smudge450 wrote:Is it just a matter of removing both side panels and they are on view ?
Yes.
smudge450 wrote:Also do i need to remove the decor door to do this job?
Yes, and the door outer.
Horrible job – note warnings about edges.
Penguin45.
Re: Bosch Logixx Automiatic SGS0902GB/04 Fault(s)
Standard fault is underfilling, thus the diaphragm switch on the end of the heater box is not pressurised, so no heat.
Basic solution is to remove the lower front panel (and plug), remove the corrugated hose revealed and clean thoroughly.
Penguin45.
Re: Sanyo EM-SL30N Combi Microwave Intermittent Heating
LJDomestics wrote:( Hope i dont get my knuckles wrapped for this idea? )
Nope, spread the word, Brother…….
Penguin45.
Re: Necht WQP12-9319: Error code “E1”
E1 is no water detected by the water level pressure switch in the time allowed.
You say it fills – if the water is trickling in very slowly, it could just time out. If the water is coming in vigorously and the water level switch is not working, the machine should ultimately flood.
What you are actually describing sounds like a “no circulation” problem – the machine in theory should fill twice – the first fill trips the level switch to start the circulation motor, which sucks the water up into the machine, effectively causing the water level to drop, which causes the level switch to drop out, thus turning the water back on again.
Hope that makes sense,
Penguin45.
Re: Sensor rotor position removal f & p Gw600
Just undo the nut (16mm?) and wiggle the rotor away to reveal the stator assembly. Access from the side if IIRC.
Penguin45.
Re: AEG Oven turning itself off
Induction switch discussed in this thread is not applicable to your appliance.
Please start a topic to discuss and prevent this one from going off topic.
Regards,
Penguin45,
Moderator.Re: Samsung P1253 – Door Seal has become wrangled
Gandh1 + LJD – please conduct any trade related discussions in the Trade Forums. Future posts of this nature will be deleted from the Public Forums.
NW – please contact spares@ukwhitegoods.co.uk with your requirements for a quote which is likely to be as competative as any for Samsung components.
Penguin45,
Moderator.
