Forum Replies Created
-
Posts
-
Re: Re-hinging doors
The part number is specifically for reversing the top hinge. Contact spares@ukwhitegoods.co.uk amd they will give you prices and availabilty etc.
Penguin45.
Re: Bosch WFF 2000 Intermittently Not Draining
Just release the two for the door lock. It’s very straightforward to put back once the panel goes back on.
Penguin45.
Re: Re-hinging doors
Bottom and middle hinges should move across. Top hinge on the early variants has a removable pin, which can be inserted in the other side of the bracket and then the whole thing can be inverted. Later versions require you to replace the hinge – p/no 49005115 – spares@ukwhitegoods.co.uk will get you promptly if required.
Penguin45.
Re: APM 8702 not spinning
We’ve told you. Dodgy Italian electronics and a hypersensitive OOB circuit. Which is part of the electronics…..
Penguin45.
Re: Servis Easi Logic 1600 Washer – tripping electricity
To try and answer the question……
If you plug it in and switch on at the wall and it trips, the mains supprssor will be the culprit.
If the machine is plugged in and trips when you switch the actual appliance on, you need to do earth checks through the heater and motor. One of them is almost certainly the culprit.
Power off first,
Penguin45.
Re: Bosch SGS4302 – not heating up and stuck on 1 minute
The cavity (stainless steel box) has to come off. To do this, there is a screw in each corner, sump moulding screws, salt cap collar, door and fill matrix to be removed. Patience job, but possible.
Penguin45.
Re: Hoover HWD120 – 80 washer drier PCB woes.
09200694 – core board – programmed
41014754 – dryer board.Chris.
Re: No power to Caple DI414 Dishwasher?
It’s a Whirlpool-built machine, so quite basic really. Burnt-out wiring at the mains suppressor is the most obvious one to look for, followed by broken wiring through the pivot area of the door. They’re easy to spot; dead pcb is another candidate and may not be so obvious.
Power off if you’re going to sort this yourself.
Penguin45.
