Forum Replies Created
-
Posts
-
Re: Smeg DWF612SS leaking from matrix/sump
From memory…
There are a couple of “O” rings where the matrix joins at the bottom – these do weep occasionally. A strip and clean will often do the trick – the “O” rings are available as a spare part – I’ll post a part number for you when I manage to find my tech disc. :rolls:
Penguin45.
Re: Dishwasher teka dw6 59 FI problem
If the machine absolutely will not re-set, you may be faced with a corruption issue, something which these SMEG-built machine are particularly prone to. This ARTICLE may prove to be of interest.
Penguin45.
Re: Bosch Classixx 1200 On/Off switch help pls
WFL2463GB/12.
There is no on/off switch. Power is switched by the programme selector. There is a start button as part of the pcb – p/no 432218, a snip at £203.
Penguin45.
Re: Indesit Wil123s lights flashing. What do they mean
You need a test meter – measure the resistance of the heater when spilt from the circuit. 25-30 0hms is acceptable. Next, perform a continuity check on the wiring. One goes to the pressure switch, the other to the pcb/module/computer/power board.
If you have resistance and continuity, the fault is in the pcb.
Power off first, of course.
Penguin45.
Re: Dishwasher teka dw6 59 FI problem
Switch on and press the programme button 4 times, within 3 seconds. The 1st and 5th lamps should light…….. You may have to do this several times before it works! Assuming that it does, switch off, count to 10, switch on and run the rinse programme only.
Penguin45.
Re: aw23 plastic base.
You don’t take the base off, you take the cabinet off, leaving all the access you’ll ever need.
Chris.
Re: Dead end search?
Drop Dave a line on the link and ask? I do know that parts have gone to France and Finland in the past, so it might be possible.
Penguin45.
Re: ISE c1555wh control knob
The only knob problems I’ve had with the CI555 is grease accumulation – pop the knob off, clean knob and fascia thoroughly, pop it back on and tell customer off.
Chris.
Re: hoover hswd146
41014218 – shaft
92445600 – bearing seal
92131689 – front plate sealBearings not listed separately, so better take some with you – 6204/5/6 a good bet.
Chris.
