Forum Replies Created
-
Posts
-
Re: miele and review sites
Typical miele propaganda. It’s a shame none of their new products are as good as the old ones in terms of reliability. They seem to have a hell of a lot more failures on their pcb’s and there after sales service is worse then ever. Although if you listen to the hype there as never or will ever be a miele machine ever brake down. :rolls:
Phil
Re: The VAT Factor
They was looking at increasing it to 20{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} before the recession it was just delayed that’s all :rolls:
Re: Miele T7644C Condensor leaking
If it’s the base it will be sealed. Sometimes you can use a syringe with a piece of pressure hose on feed it in from drain pump side (take drain pump out 1st) and drain it out and watch the fluff/blockage come out but you have to keep doing it.I also usually pull the heat exchanger/condenser out and keep pouring water into the drain from there so when the water starts to run clear i know the blockage has gone hope this makes sense and helps.
phil
Re: Word of Warning
complete and utter scum bags they need hanging!! It’s happened to me not nice! I hope you catch them.
Phil
Re: miele g646sc no heat.
Pressure switch not pulling in heater relay? just a shot in the dark if everything else is metering out ok.
phil
Re: Miele MT 2670 – stopped drying!
Hi, yes it is an overheat stat so there will be a problem somewhere be it a blockage(usually in the plastic channel at the back absolute pig off a job!) or just poor circulation so it might be wise to call the engineer in anyway.
Phil
Re: Indesit W855G won’t fill
follow hose down from pressure switch will lead to a chamber thats the pressure vessel.
power off
philRe: Miele MT 2670 – stopped drying!
Is this the washer dryer? if so look under the lid(2 torx 20 bits on side of lid) and sometimes on top of the dryer duct there is a thermostat with a red square/button press it in if it clicks everything should work ok again for a while but the chances are its a blocked condenser channel at the back of the machine clogged with fluff which needs cleaning/replacing or poor circulation fan etc.
POWER OFF FIRST!
hth phil
Re: Snow….
I think penguin as got a distinct unfair advantage in this weather hence why he does not get stuck anywhere! 😆
Re: Hotpoint wf540
Thanks jim. Sorry for the hassle it as been a very long day would not mind i must of read that at some point it i have the fault code book!!!!
Re: Miele Novatronic W1512
There is a way of reprogramming it for low water pressure it just extends the fill time. Check in user manual sometimes customers can programe the machine to their requirments otherwise it will be a miele engineer job.
Hth
Phil
