Forum Replies Created
-
Posts
-
Re: Hoover/candy HFI4015 (D/W)
rocker wrote:Has a E8 fault showing..have put meter across supply to heater..240v showing for a minute or two, then voltage drops out..cant see any dry joints on board.. but does seems like a board fault !!..is there anything else that could cause this and need checking first. before buying new board! thanks John
or send it to emw @tony he does them but only if no heat fault
machineman wrote:Blue boiler suits and yellow leyland j4s with a sliding door .those where the days
Daveya no central locking ,no sat nav,no ele windows,no power steering and no mobil phones ,good old days 😆
SteveATY wrote:Okay, been to have another quick look at the machine. I got the customer to stick the machine on pre visit so it would be glitching when I got there.
The fault isnt quite as originally stated! The program does not flash a fault code. Instead it just seems to be stalling. It sits there doing nothing for 10 to 15 mins at a time and then will suddenly spin the drum (slightly quicker than wash speed) and then back to nothing for another 10 mins or so. All the while the ‘washing’ light and the ‘start / stop’ remain fully lit.
My guess is control board? These are £130 a shot retail.
Steve.
had one doing same chang pcb no joy luckiy had motor change it cure the fault 😆
Re: brazing torch
iadom wrote:Twas my neck, still get a bit of stiffness at times but have full movement. I will have to get a cushion to lie my head on when working underneath machines. 😀
Jim.
always lying down on job 😆 what a lifeRe: aeg d/w
dealdd wrote:how much of a gap should be at each end i would have thought they should be right to the hinges to stop splashing over the edge
should be gap each end 1/2 inch
Re: how bright should a magnetron be on a microwave?
torxhead wrote::rotl:
is it an expensive oven, yes, trade price they cost £550 each. ive got 2 to repair.i suspect the magnetrons are at the end of their life, but at £110 each, its an expensive part to fit if i am guessing.
there is 3v to the magnetron, they both meter ok, i just wondered if they are supposed to glow really bright or not. 😳
Re: Hoover HCF 6200 A. temp probe location
DOCTORDOOM wrote:Hi. I’ve got one of these overfreezing and from reading posts I suspect fridge temp probe is faulty. Can anyone give me some measurments for where I should start digging or even just a rough idea. thanks. Just to make sure I’m on the right track the freezer is also getting to -27 but I’m assuming this is also due to fridge probe.
could be pcb most times it is
Re: Hoover HFA270 fridge freezer freezing in the fridge
i sure there is one buit in at back you got to dig out form
Re: scrap prices
then chinas man take it to china melt down make it ins@@ machine sell back to us in 12mnts time scrap we take to scrap and sosos
