Forum Replies Created
-
Posts
-
Re: Zanussi condenser dryer fault codes ZDC67550W
Can’t find info for this model but if you’ve a Connect account you should be able to use info from ZWD16581W in mediator. It has same system as your model. Hope it helps.
Re: Hoover VHC391-80 T/D Tech info
Returned to this machine today. Fitted front sensor but no joy. Machine still cuts-out after five minutes. I could hear one of the relays on the pcb clicking as the dryer cut out. Could this be the point at which the motor reverses ❓ Does this model have reverse action ❓ ❓ Not had any replies yet, so here’s hoping 😕
Re: bosch sms50e02gb
E21 is circulating pump blockage. Possibly plastic wrapping off of something where plates haven’t been rinsed off. E24 is drain filters blocked.
Re: Drum Shaft Kit (Hotpoint VTD00)
Make sure the drum hasn’t any damage where it’s been hitting the motor. Had this a few times.
Re: Hoover VHC391-80 T/D Tech info
Hi, I’ve a repair with exact symptoms. Switch on, tumbles and heats for five minutes, halts and after a few seconds the start light flashes continuous. Can’t find fault codes for these but guessing front sensor. Resistance is around 18.5 k/ohms at room temp.
Re: Kenwood KDW243A/A
Might be bad connection to/or flow meter on the air breather (behind side panel). Had exact fault with Bosch and Beko dishwashers.
Re: Beko WMA620W Door assembly does not fit
Its mentioned on the Beko technical website & shows graphic of different cut-out in the metal of front to accomodate changed support, can e-mail you info if you need it.
Hi, Any chance of sending me a copy 🙂
Re: Hotpoint WDL540P UK C dryer ntc
Just concluding this one. NTC had a very slight insulation fault caused by damp entering the cap. Fitted direct replacement with plenty of heat silicone to reduce a repeat occurrence. All good 😀
