Forum Replies Created
-
Posts
-
Re: *** Feb Whitegoods Conference ***
Not been to one of these yet. Is it the kind of do wives / girlfriends come along to?
Re: Bosch SMS69L12GB/18 – Service Manual
I would like info on these if anyone wants to send it me for a christmas present! Not fixed one but sold a couple. 😀
Re: Hotpoint BCI450c
Hi guys. I see a lot of posts regarding the 100 bit pcb. Haven’t repaired any yet. Do you buy these configured or do you have to have the card reader etc?
Re: Beko DRCS68W condenser dry belt + modif info going on Mo
Thank you seamy. All good advice.
Bobhope I have pm you my e-mail address. The more info the better. Thank you guys for your trouble.Re: Hotpoint CTD00
Hi
Some of these did have a modified rear cover with a drilled hole and a felt pad on the outside. The Hotpoint guys will tell you more.
A bit heath Robinson but what do you expect…..Re: Beko DRCS68W condenser dry belt + modif info going on Mo
Thanks Preggy. Better allow a bit of time. I presume it’s a tight stretch belt with no jockeys?
Re: Neff U1721N2GB/01 Oven Blows Trip
Yes go for the fan motor. I had this problem a few months back, I think I posted something about it. Like you I was surprised as it’s not something fan motors normally do. Again I had good readings.
Re: Beko DRCS68S S/N 09-206777-12 condenser dryer no heat
Thanks guys. No doubt it will be the none resetable one for me! :rolls:
Re: whirlpool AWO/D 5556 859297115005
Hi. I went to a AWO/D 5526 last week not the same fault as yours and I had a reply to my post saying they were prone to pressure bottle blockage.My model it is moulded in to the outer tub. Dont know if yours is a similar model. Just a thought.
Roger.Re: Whirlpool AWOD 5526 not spinning properly going tomorrow
Update on this one. Rang customer and went and had another look. Dismantled front removed pressure pipe from pressure switch, blew down pipe, clean as a whistle. Put back together after checking motor wiring again, tried empty on rinse, tried empty on spin all worked fine. Asked customer for a few towels, tried it with a load in, all worked fine.
Customer is now going to use it for a week and let me know how they get on. I’m now beginning to think this machine may have had an air lock. It has a clean filter light which I think should have illuminated if the pressure switch was held in the full position after a time out period. If the pressure switch kept re-setting and therefore reset the pcb timer it may just act as if there was, for example, a suds lock. There are a couple of thin low voltage wires on the pressure switch, so dont know if this is a frequency also type pressure switch. Will let you know if it fails again 🙂Re: Whirlpool AWOD 5526 not spinning properly going tomorrow
Cheers Mickey 32. I’ve been today and must admit I haven’t checked the pressure chamber. It looks like the type moulded into the outer drum. It didn’t throw any time out errors just would keep restarting the distribute process. Do you know if these throw an error if the pressure switch doesn’t reset? It’s only a year old, advised customer to have a word with Whirlpool, looked like pcb fault.
Re: Whirlpool AWOD 5526 not spinning properly going tomorrow
Cheers Mike. Just going to make my way there now. Got the CESET’s on board anyway.
Thanks for the reply.Re: Indesit IWDE 12UK 80523900000 removing condenser?
Thank you for that. Will wait and see if they call me back, and at least i’ve got an idea now. Thanks again. 😀
