Forum Replies Created
-
Posts
-
Have you checked vent hose that runs from the dispenser to the fan housing ,also turn down the water on the taps so it flows in without splashing.
royPlease can you send me a copy Thanks Roy
Have you taken checked the drain hose fittings
at the top of the machine found a 5p stuck in one
the other week, another engineer had charged her for a new pump and would not come back.Have you tried removing the lower seal and
re fitting it with a bead of silicon then fix in place with 3 or 4 metal clips.
I have found this works very well.
RoyThe best way to fit a belt on the new vented dryers is to buy a woodworkers ratchet cramp and remove the end jaw, make a slot in the end then with the belt fitted on the drum with r/h side panel removed lay the machine on L/h side pass the end
of the cramp through the slots under the motor
fit the belt into the slot and tighten cramp the belt stretches down over motor pulley, belt fitted in 10 seconds Roy.Also remove module and clean the board contacts and tighten the edge connectors by squeezing
with pliars (can give fo8 fault even on spin).
RoyCheck motor loom & plug the conductor breaks in the insulation, if ok remove module & check had
a few blown up Emw unable to repair.
RoyHi had problems with a 960 sticking on 1 minuite
the fault was on the motor loom & plug, pull at each
wire going to the plug they break in the insulation.
hope this is of help.Roy
Replace the interlock,and repair the blown track(s)
or remove the wire fom the connector block
and solder it onto the next junction on the
control unit.
RoyRemove the condenser and check the circulation
fan is clean, make sure the customer is allowing the dryer to go through cool tumble.
Also change the front drum stat.
RoySome bosch dishwashers set the program time
based on the previous wash cycle on that setting
or factory test then adjust it when the program
is running.
Roy
