[roy1]

Re: Tecnik TKD795 D/W Not Heating

Have you checked the board for a blown track on the heater relay.

Roy

[roy1]

Re: Hotpoint TL52 tumble dryer.

The hotpoint TL 52 has the 170442 belt, but the TDL 52 has
the 1701658 stretch belt.
Roy.

[roy1]

Re: B&Q £149.00 Hoover washer,how???

I was told last week by a customer who works for B & Q that they are going to stop selling free standing appliances, due to the amount of returrns for vibration, leaks and that they are unable to answer
customers questions.
Good news.

[roy1]

Re: Hotpoint WMA Washer draining problem

Have you removed the pump non return flap, they can cause a problem.

[roy1]

Re: WMA 11

yes remove the eco ball in the sump hose, the ball can stick.

[roy1]

Re: WMA 11

I would replace the pump and remove the eco ball also is it connected to a sink sprigot?.

[roy1]

Re: hotpoint wd420

Had the same problem a couple of times after checking fan,valve ,blockages & overloading.
The fault was the thermistor ,I now always change the thermistor with
every cut out failure.

[roy1]

Re: Hotpoint WD440 Error code F12

Check the cable & edge connectors between the boards,if all ok
it`s an eeprom error.
Another job for EMW

[roy1]

Re: Hotpoint WMA36 Overfilling

I had a problem with a wma overfilling after cleaning sump ,replacing the pressure hose,pressure switch & valves it turned out to be a module fault.
You can get the pre wash light flashing on overfill with a pressure system fault.

[roy1]

Re: Htp wd64

Have you checked the filter, a part blocked filter will give you an increased amount of water in the tub.

[roy1]

Re: hotpoint wd440p

The 3rd & 4th led is the fault code for Nct short/open circuit, change the
dryer thermistor & check wiring to thermistor and board.
The fan, pump, and valve are switched on when a fault occurs

[roy1]

Re: Hotpoint Washer Dryer WD63 Eating TOC Kits

check the motor loom for damage at the 2 cable ties on the cabinet, had a few with this problem.

[roy1]

Re: hotpoint 31330 vtd00p

Fit the drum shaft repair kit, contains spacer,shaft, rear seal ect .
If it looks like the drum will still rub fit 2 spacer washers.

[roy1]

Re: HOOVER AL110 – Airlock ???

If it’s one with the pump and filter assy check it’s not got a 1p coin stuck in the small sprigot on the pump/filter, has to be a blockage.

[roy1]

Re: Hotpoint WMA 40

Why not run the module test program to find last fault.

[Author]

Posts