[roy1]

Re: hotpoint wf740 sticks on 1 min.

A burnt connection in the motor plug can cause sticking on 1 min

[roy1]

Re: connect thermostats

The frg6600 is a crap Ranco copy, they turn round & round, overfreeze
terminals are loose & bend.

[roy1]

Re: Hotpoint wt960

I allways take the weight off wrap tape around the plastic lugs
untill the weight fits tight,and put some superglue on the bolts.
Never had a problem after that.

[roy1]

Re: Indesit WIXL 143 Door frame.

The cable tie is stronger than the origional plastic.

[roy1]

Re: Hotpoint WM83

I think the current drawn on the FHP motors is very close to the
fuse rating,i have had them blow if the machine has been overloaded.

[roy1]

Re: Hotpoint WD860 3 phase control trips RCD

I was sure it was the supressor, but still faulty.
Called Tony at EMW he thought it was the main board as the fault
only showed up when the suppressor plug is in, another scrap machine ,
fitted a new display board two months ago and that was the
second one thanks for the help
Roy.

[roy1]

Re: Re Bosch Stand Alone Siver Dishwasher display dies and r

Had same problem faulty board sent back to QER for repair.

[roy1]

Re: Hotpoint WD860 3 phase control trips RCD

The machine does not have a moulded plug,I checked the plug connections all ok, also the fault would not go away if you unplug
the mains suppressor thanks for any help.
Roy

[roy1]

Re: Help please ? Hotpoint WD440 !

Have you checked for water leaks on the heater box and
around the grey pipe connections, it can drip on the module
and cause it to trip.

[roy1]

Re: ariston a1436 f10

Open up the plug to the pressure switch, had two machines in
the last week where the cable had burnt.

[roy1]

Re: Hotpoint washer dryer WD420

I have had the same problem in the past, now when i get
a cutout failure i always change the thermistor.

[roy1]

Re: Hotpoint CTD85 tripping.

The only modiforication you need for a ctd dryer is to take it
down to the scrap yard, and crush it.

[roy1]

Re: Hotpoint CTD85 tripping.

I have tried the same trick with the hairdryer, but trips again a few
loads later. The only solution is to replace the heaters, i think its
down to poor quality insulators
Roy

[roy1]

Re: Belling fridge problem

It sounds like it could be a blockage in the evaporator plate,
if thats the problem then its time for a new fridge.

[roy1]

Re: Indesit WIA 101

Thanks for the help,another job for EMW.

Roy.

[Author]

Posts