Forum Replies Created
-
AuthorPosts
-
Seamy
ParticipantRe: Non return valve on the cold supply?
I remember them coming with Miele commercial washers to comply with WRAS regulations , they’re like this..
Seamy
ParticipantRe: Stoves 900EF circulation fan motor
081733300 FAN cooling USE 082465300
available here
Seamy
ParticipantRe: Miele G1220SCI Integ dish washer
Possible blockage of the impellor on circulation pump, strip it down & see if there something stuck in there preventing flow of water, normally plastic wrapper.
Seamy
ParticipantRe: Miele door seal
I’d be trying a patch at that price
Seamy
ParticipantRe: AEGF35080V1 NO HEAT
It’s a Dishwasher, it’s more likely it’s a bad drying complaint they have, advise to use rinse aid. Heating fault could come from dodgy relay or bad soldered joint on p.c.b,
Seamy
ParticipantRe: Hotpoint int’ fridge , gas or comp?
r600a wrote:Model number ?
HUL1611
Seamy
ParticipantRe: Beko help needed…
washman3 wrote: reset machine by pressing 2 buttons overhead padlock symbol for 3 secs.
washing perfectly again. thanks for help.
Had you tried child lock reset before changing switch? :rolls:Seamy
ParticipantRe: Stoves 900EM grill regulator
082278701 listed as thermostat for 059042384 nothing for model listed.. try..
Seamy
ParticipantRe: miele t494c not collecting water and burning clothes
slyp98 wrote: do you know where i can get parts here beside the miele main distributor ? thanks kieran
Seamy
ParticipantRe: Miele W865
Brushes
Seamy
ParticipantRe: Zanussi ZWG1140M
Think its caused by a fauty triac on board, PCB should cure it
Seamy
ParticipantRe: How do YOU pronounce it?
I was chastised at a Miele training course for calling their brand Meela, its supposed to be pronounced Meeluh,
I believe Beko should be pronounced Becko & Gorenje, GorenyaWhat i’d like to know is a washing machine masculine or feminine, most people refer to it as “she”, any thoughts?
Seamy
ParticipantRe: Miele g1140sc. Dishwasher
Was there water spilled into base? Maybe the float switch is being activated. Or could be not enough pressure from circulation pump motor to activate high presure switch.
Seamy
ParticipantRe: miele t494c not collecting water and burning clothes
Should be acessed from back on right hand side, theres an access panel which needs to be taken off. Disconnect pipe & plugs to pump & reed switch first. There should be a retaining lug on left of pump, press it down & pump should turn anti clockwise & lift upwards & out. Make sure not to lose little ball for non return valve that falls out. Thats how I remember doing them.
Seamy
ParticipantRe: Zanussi ZDC5350W showing E20
E23 is normally the triac fault code, E21 normally just blocked pump, faulty pump etc
-
AuthorPosts
