Forum Replies Created
-
Posts
-
Re: Miele G7859
Did you open pump, most of them you can dismantle & remove obstructions from impellor .
Re: Using Oven without cooling fan, is it safe?
When you say its not working be aware these are switched on only when temp’ in cavity rises & will stay on until temp’ in cavity drops below a predetermined setpoint. Thermal device is usually in circuit to switch on & off. It will be dangerous to operate the oven without the cooling fan running as designed & could be a fire risk.
So no its not safe to use oven without cooling fan!Re: Zanussi ZENB2625S – Fridge Problem
Switch off & defrost appliance totally for at least 24 hours. Se if that cures problem.
Re: Miele fixing brackets for under granite worktop installa
Try contacting
Miele Company Limited
Fairacres, Marcham Road
Abingdon
OX14 1TW
Telephone: 0845 365 0555
Fax: 0845 365 0777Spare parts dept’ 0845 365 6605
Customer support 0845 365 6600Re: miele d/w g694sc
Have you checked the filters, they have a tendancy to collect plastic papers off tablets in filters & pump impellors, is the outlet hose kinked ? There could be a problem with the appliance not detecting water level.
Re: Miele G7859
would imagine the fault code has arisen when pressure is switch not activated after signal sent for circulation pump to start. no service info on them anymore sorry
Re: ZJD1219 skipping programs
Would be lookin at drain hose before taking it out make sure that its not siphoning after drain-out of water & next fill then not acheived. Heater also would be worth a look at if & when you get it out.
Re: Zanussi ZWC1300W – module or door interlock?
Most likely fault from what you describe & taking into consideration the location is a power supply problem. These are very sensitive to voltage or frequency fluctuations.
Re: Tricity Bendix AW 1002 W keeps pumping.
Go into diagnostics, step 2 should take in water, after filling empty out. switch on & off again. Sometimes that will reset it.
Re: Beko drum lifters
From Feb’ 09 machines were manufactured with a welded tub, the drum baffles are screwed in & a tub change is required.
If its an earlier type with split tub you can change them.
2812260300 is the drum lifter part num’,
9003271900 is the screw, 2 needed to secure each baffle.Re: zanussi zwd 1627
Not sure of the model, PNC would help. If its a ZWD16270 there is a dryer pcb, check communication cable & connectors between both & dryer heater resistance to earth first.
Re: Zanussi DE4744 D/W
summit stuck in pump i suspect, take out water with cup or glass & sponge remainder from sump, then check pump
