Forum Replies Created
-
Posts
-
Re: Hotpoint WMA35 1st & 3rd led’s flashing
Failure to empty in alloted time.
I’d be looking at blocked filter, sump hose blockage or pump failure.
Re: easi-rent
Well they’re using the ISE machines…
I personally don’t see much of a market for it, most high street stores allow you to purchsase your own machine on credit & at least it would be yours afterwards.
Looking at this after a year & a half or so you could have a machine payed for.Re: whirlpool ADG8977 d/w with F8 fault
Well done in Minor Game. 😛
See Known Error codes.. page 2
F8. 8 Flashes. Water level failure. Sieve strongly dirty or big amount of foam inside to less water.Re: Tried Everything (nearly), Still Problem, Help! HVR HC12
Had a problem similar to this with a faulty pressure switch on these machines before.
I think from memory it thinks its in flood condition, when it gets wrong signal from pressue sw’ .Re: Whirlpool AWM 6100/3 not emptying or going to spin
Thanks for that I do have a Whirlpool Sios disc from 2002 but this model wasn’t listed, can I do a software download to update it with recent machines (if so from where) or do I have to get a new disc?
Re: Miele professional 32Kg manual
Only information i have is Wiring diagram & legend on file if thats any help
Re: Whirlpool AWM 6100/3 not emptying or going to spin
HELLO…
How do I “Enter into service mode” ?
Water is drained out of machine, pressure vessel is not blocked.
Re: Whirlpool AWM 6100/3 not emptying or going to spin
OK back to same fault, Electronic buzzing, pulsing sound coming from electronics, drum will advance a few milimeters at a time but won’t go into spin. Motor looks healthy, brushes are good & armature clean.
Tacho also looks & meters ok.
I was wondering is there any test or reset procedure for this machine?
Do Electronic Controls cause much grief on this model, I don’t see an awful lot of Whirlpool.
