Forum Replies Created
-
Posts
-
Re: Miele g1182scvi dishwasher
Does it fill with water or not, or does it start wash motor & then go off, they have a high level pressure switch mounted on circulation pump which will knock off the programme if its not energised when circulation pump is running, this could be that not enough water has filled in or that theres a blockage in the circulation pump impellor. Another known error of them going off early is faulty heater relay.
Re: Miele WT2670 Dryer Condenser Unit Location?
The semi-clear plastic unit on the left hand side of the machine is the condensing unit. Cold water is fed in through the valve while on drying cycle, the cold area from the water flowing condenses the steam & aids drying. Check fan is not blocked & that appliance is not trying to dry a full load. Think they will only dry a half load, the time is probably calculated by the load sensor because of heavy load.
Re: New World grill element
081561400 ELEMENT grill dual
Re: Beko A+ class 1000rpm washing machine fault
Its a WMC61 & i’d be checking the motor brushes are’nt worn out.
Re: Miele g1270scvi non return valve
Try Miele direct on 0845 3650555, whats the problem with the non return valve anyhow?
Re: Zanussi Dishwasher zsf 6120 – heating problem
Power off on any testing.
I’d reckon it’ll be a P.C.B 1527909905 that you require, check the heater for continuity first to make sure its not open circuit.Re: Zwg1120 zanussi washing machine
I’d be checking the analogue pressure switch, connections to it & motor etc, connections to valves, p.c.b. Check the pressure vessel & pressure tube for blockages. Theres has been an issue with them going into spin on wash speed but they usually throw up an E62 error code
Re: Zanussi fx 1465w not starting
Check components for short to earth, heater & motor in particular. Check connections to components especially the pressure switch & door switch. Does any error code come up when it shuts down, does start l.e.d flash? And if so how many times.
Re: Lavamat 52610 suddenly stops
Check appliance in another socket outlet to see if its a faulty socet causing the problem, check door interlock & loom to it. If its an old type washer with the timer knob used to pull out to switch on & in for off it may be that the on/off contacts are damaged.
Post 9 digit product code from your machine to be certain the information you get relates to the product you have.Re: Evaporator Fan
Control board is working if its coming on in test mode, fan gets its supply through the pink wire from the main board.
Make sure you have not dislodged some of the sensors while working at the evaporator section.
Are you sure both door switches were closed whle testing, I remember been baffled as to why one would’nt run & it did’nt start till I made door switches.Re: Zanussi ZWF1021 brushes
Most likely you need 2 x 50226588007
