Forum Replies Created
-
Posts
-
Re: Whirlpool ADG7560/1 circulation pump/heater conversion
Can this post be moved to trade technical enquiries please?
I have diagnosed circ pump seized(askoll looking but white bayonet CPO pump) on this UKW job and you can hear PCB trying to start it about 6 times after fill finishes. To try and correctly diagnose the fault i fitted a normal drainpump (bosch) onto circ pump wiring to see if it was definately the circulation pump. when reset drain pump ran all the time but the hoax circulation pump ran all the time on drain as well and not finishing reset.
it ended finishing with 16 flashes when shortwash selected (different coil resistance perhaps?).
Does not flash 16 times if seized circ pump reconnected it just ends the cycle no error codes if shortwash selected.
This is the dishwasher that ends up error 4 if the wash arms are blocked and i cannot see how it checks pressure unless it moniters the circ pump current draw.It is cheaper to replace heater and Circ pump Than buy the circ pump with inbuilt heater but does anybody know if it will work as i have to ask customer for more money for CPO pump and i know it will fail in just over a year again.
Cust is Lab equip technician as well.
http://www.ukwhitegoods.co.uk/modules.p … 1&start=30S.
Re: Indesit idl40 drain pump o-ring
Never had a problem before but will now start undoing the 3 screws i think.
Re: Whirlpool ADG7560/1 circulation pump/heater conversion
Just rang Whirlpool. 481236158478. £198.72 😯 . Special order from masterpart.
S.
Re: Whirlpool adg7540 dishwasher cold water only
P have been to this. It is the circulation pump (seized)that has the heater assy in the impellor. Has it to be modified with new heater fitted in place of the plastic tube and the usual askoll replacement circ pump?
S.
Re: Indesit Widl126 dryer thermal fuse
Yes thanks. I would expect timed to at least finish but cold. Is it just a microtemp which i carry on van or a TOC?
S.
Re: Indesit idl40 drain pump o-ring
Received part. a lot thinner and smaller diameter than original part. Odd.
S.
Re: Prima LPR 600/1 Fails after a few minutes with beeps
Then open the door. flash code should repeat itself with a pause inbetween.
S,
Re: Hotpoint DWF70S AL02 fault after fitting drain pump
Now worked for a week customer came downstairs in morning as drainpump has been running all night. Checked base dry no water floatswitch ok. LCD has scrolling figures. Unplugged,plugged back in LCD now fine and quickwash cycle completed ok.
Wish i hadnt started this one. 😥S.
Re: Bosch Dishwasher Dispenser
Yes happened to me. Replaced module UKW job because of usual dryjointed faulty heater relay. Totally unconnected one month later module blew up due to dispenser actuator going short.Blew tracks off board on mine. Had to cover warranty on module unfortunately due to UKW charter rules.
S.
