Forum Replies Created
-
Posts
-
Re: whirlpool 20 rbd 4a+pt no ice
seems to be clear at the pipe , anyone have info on the infra red emmitter and reciever setup thanks
Re: whirlpool 20 rbd 4a+pt no ice
hello hello hello is there anybody out there ? just nod if you can hear me .. is there anyone home ? so i removed icee makeree and checked it manually with flying lead and hey it works, mould heater ok , motor spinning round , fingers moving with motor , now the water is dispensing from the flap in door , but no water dropping into the mould , are the 2 linked by one valve or are there 2 seperate ones thanks
Re: samsung rs21dcns tripping rcd
this is a joke the defrost tray heater that i replaced is tripping the rcd again and it has blown the defrost heater and the defrost sensor ?? wtf samsung !
Re: miele t494c not collecting water and burning clothes
hi Conor , i got the drum out you were right it wasn’t too bad just loadsa screws , anywho the pump was a little dirty but not really bad but i put some water in the bottom of the pump tank and it stayed there so i’d say it was a blockage in the hole at the bottom of the pump tank ,all back together and turned her on but she stopped after 20 0r 30 seconds with an alarm beeping so i had a look around and i see a bent connector on the main pcb just below the heater relay i have a drawing from inside the m/c so i had to remove the connector to straighten it on the board and resolder , but still no joy so itraced it back to the relay above this connector not energising ie nothing coming through the relay , also dead giveaway elements not heating , its possible i could have damaged the connector and the relay has a little bit of white plastic like a tang or hinge of some sort making noise when the board is shaken , i can only try a board i guess do you know where i can get parts here beside the miele main distributor ? thanks kieran
Re: de dietrich fan oven low heat
ok guys had alook at this model and its reaching temp. just about 177 for 180 and then the relay cuts out and it drops to 150 and then back up again process takes 4 or 5 mins costantly doing this , no dry or cracked joints on control boards ,,, could this be a thermostat fault , i got a reading of 438 k ohms from the stat ?
Re: samsung rs21dcns tripping rcd
replaced defrost heater and it ran fine , but customer rang to say it wasnt so cold in fridge , and fan making lots of noise ,turns out the evap is clogged with ice and the fan also ,
Re: indesit WIA 101 uk
worked fine until last week , goes through any cycles in about 20 mins takes in water , does a quick drum agitation 7 mins , takes in about 8 litres of water slow drum agitation then drains, a quick spin takes in 8 more litres slow rotation again and drains finished also only heats water to around 15 or 20 degrees and 156 volts going to element ,, main module problem?
Re: miele t494c not collecting water and burning clothes
Hi Conor , it hasnt tripped the rcd and i can blow through the hose its coming from the pump area thanks
Re: hotpoint bd32 cooker fan not working
cheers gandh1, how do you mean push knob is this with the spring between the grip and the dial ? this model has 3 knobs, they can be removed by pulling them off the switches one piece construction with spring circlip around shaft of knob it has 6 push button timer/clock also . it sounds like its a bd32p mk 1 i’m afraid the guarantee and user manual are long gone . are diagrams available for the mk1 ? or do i still need a pnc cheers
Re: hotpoint bd32 cooker fan not working
fan is working fine loopey , i need a wiring diagram really but i have no rating plate/sticker nothing to go on !!someone else was at it replaced the fan last year !
