Forum Replies Created
-
Posts
-
Re: hotpoint bd32 cooker fan not working
customer still having trouble with this oven working fine but it wont stop heating keeps heating at fullpower even though stat is down at 80 degrees , any help thanks
Re: hotpoint WD 63S tripping rcd after cycle
customer told me it tripped on the final spin today , so i’m heading in the direction of s/p motor
Re: hotpoint WD 63S tripping rcd after cycle
as far as i can tell a minute or so after the light goes out , it happens every time and it trips once, when you reset the rcd it stays on ok even when the machine is powered on , until the next end of program that is ho ho ho . i didnt buy a megger cause i was under the assumption they were mega expensive get it MEGA … anyway i just seen one on rs.com for 25 euro !! could this be true a proper megohmeter ?
Re: hotpoint WD 63S tripping rcd after cycle
i’m just trying to get my head around the fact the machine is finished the program stopped for like ages 3 or 4 mins and then it trips ???? . i dont have a megger , so all i can do are continuity tests and a 10 a load test will this be sufficient , also is it possible that the carbon dust is causing this ? thanks Dave
Re: miele t494c not collecting water and burning clothes
anyone have anymore info on these beasts of things thanks
Re: miele t494c not collecting water and burning clothes
there’s a small connector panel where the main power supply enters its 70mm x 40 mm on the back (looking from the back ) bottom left h/s of the machine nothing else there seamy looks like access could be gained by removing the motor support bar running at the bottom of the m/c lots of stripping to be done though , i cant see another way except taking the whole m/c apart ie ; , drum out thanks
Re: miele t494c not collecting water and burning clothes
Hi again Seamy , how do you gain access to the pump i take it thats it behind the plastic ducting and the motor
Re: electrolux EKC 6046K cooker low grill temp.
yeah it seems that way alright , 12.7 ohms from one set of tags and nothing from the other 2 cheers
Re: liebherr kes 4260 larder fridge
hi alf , i checked the control board today , 3 connector blocks on it 2 on one end one on the other next to the stat , the wires next to the stat are blue and red two core white and when tested with a meter i’m getting 14.6k ohms surely this means sensor is working ok ? the other wires are brown and blue 2 core and brown, blue and black 3 core .
Re: bosch sgs46E02GB/75 not pumping out water
cheers martin will do, also the drain hose is fed directly into the sink p- trap which is below the level of the actual waste pipework after the p-trap , if you get me their is a good bit of water to push out into the waste pipe before gravity takes over could the pump be under pressure trying to evacuate too much water ?
Re: liebherr kes 4260 larder fridge
hello again fellas , anyone have tech info for these or what the sensors should be reading thanks
Re: samsung rs21dcns tripping rcd
yeah connected every plug connector except defrost and it ran, although i did have to plug them in when it was turned on , it wouldnt start with them plugged in and then turned on , just kept hearing a loud thud from the compressor area and it would’nt come on but it was’nt trippping the rcd either
Re: samsung rs21dcns tripping rcd
checked fridge side and when the defrost heater is unplugged the fridge runs ok , but without led dislay ,
