Forum Replies Created
-
Posts
-
Re: zanussi F1045W drum paddle removal
i tried all of the holes and it slid twoards me eventually ! still couldnt get it out i had to lever it off with a screwdriver !!
Re: hotpoint bd32 cooker fan not working
hi all , i was back at this cooker today turned on selector switch nothing , tested thermostat i replaced previously , seemed ok i had another spare to hand so i put that one in and it was working , i swapped it for the original i fited and hey that worked also ?? , i have a digital temp reader and probe on my meter so i stuck the probe in a hole at the back of the oven cavity and turned on the oven to max. 220 c and the heat kept going 230 ,,, 240 ,,, i turned it off at 246 c element was bright red fan working fine , is there a problem with the stat still ??? or could it be an over heat protection prob ? anyone use meters for checking temps ?? thanks fellers
Re: zanussi zkc 5030w live going to neutral ?
changed the lives and neutrals to their correct connectors and wired a new neutral from the main connector block and all is well
Re: hotpoint bd32 cooker fan not working
does anyone have wiring info on one of these any model will do im sure the changes were not huge from each model thanks also as a side , the customer has aluminium foil in the bottom of the oven would this cause problems with the stat??
Re: zanussi zdc67550w cuts out after 4 or 5 seconds
yeah i hear ya there cost doesnt justify it , i’ll keep diggin for now thanks
Re: zanussi zdc67550w cuts out after 4 or 5 seconds
i went through the diagnostics martin cheers and i have 3 positions of an error code e51 twice pos 5 and 6 and e32 once pos 8 they are corresponding with the motor , wiring or the pcb ive checked the motor all is well , i dont fancy going through all the loom to check continuity , have you ever come across this ? before i order a control module
Re: siemens se26t550/gb not pumping out
took pump motor out and bench tested , working fine ? replaced motor and it pumps out the water ? on the start of the cycle the intake of water through the matrix , this problem is happening again when the matrix fills to the top and lets the water down into the metering block assy , it starts this activation of the red float in the chamber its a round clylinder approx. 30 mm h x 30mm dia. it looks as if the water pressure cant fill the sump anymore and overflows into the chamber , is this normal? this happens on every cycle and activates the switches 4 or 5 times then gets on with it then after 2 or 3 washes the pump stops working ? customer getting annoyed , i have removed a bit of gunge from the sump to the metering assy pipe and some other detritus , the black stains on the lower part are just that its not a blockage , anyone have a clue to this beauty ? picture of assy here thanks
Re: hotpoint bd32 cooker fan not working
all i can find is bd 32p nothing on the door surround where else should i look
Re: hotpoint bd32 cooker fan not working
well that lasted 24 hours , fan stopped again , same as before no power from the stat , i have power coming into the stat but none going out . just wondering if anyone has diagrams for wiring on these fan ovens thanks
Re: whirlpool awo/d 4605 help !cant slplit tub
unbelieveable , is there a sticky for these, makes sense not to have to do what i did, 1 and a half hours later !!doh
