Forum Replies Created
-
Posts
-
Re: Miele T5213 Dryer
I got the part number when I phoned Miele today 2631162. I then asked for some technical info about the machine, and they basically told me to pi$$ off because I am not an authorised dealer.
What a terrible way to treat someone when they are willing to take my £78.00 for the part, and not give any support.
Re: Electrolux 727043 Glasswasher
I am not sure about your one, but as with others I have seen, the drain runs while the machine washes and rinses. As long as the stand pipe is in place this is normal. HTH
Re: warning- a cooker thats still on when its off.
A few years ago I went to a Miele commercial dishwasher on a ship. I switched off the main switch to work on the machine, but I got a big shock. It turned out that the machine had 2 live supplies to it via 2 double pole switches. The 2nd live supply was for the heaters.
I dont work on ships any more
Re: Whirlpool Top loader, 3RLSQ8533JQ1 – painfully slow hot
The last one I got was from Panks Pumps of Norwich, who are a local agent, with a trade discount it cost me £156.00 inc vat. The flow switch version, i.e. RGFL250 is about £40.00 extra.
HTH
Re: Whirlpool Top loader, 3RLSQ8533JQ1 – painfully slow hot
neon_3SP_glow wrote:I think it is that pump at fault.
🙂Why not replace the pump yourself and make some dosh. I always use a Stuart RG250 and have no problems http://www.kgnpillinger.co.uk/_assets/documents/180.pdf
If you dont want to wire it to the machine, then use the same one but with a flow switch.
Re: Zan ZDQ695X – Earth Fault…
I had a cooker blowing the main fuse (yes fuse) because of a faulty lamp holder. It also took out the thermostat (the internal switch which feeds the lamp and fan). After fitting a new thermostat I tested it without a lamp and it was fine. I put in a new lamp amd bang the fault was there.
So I would test a lamp holder with it disconnected and a new lamp fitted
Re: Diplomat (Whirlpool) ADP8332 Dishwasher 11 flashes
Thanks for the reply. Since my post I went and replaced the diaphram switch, and it seems to be working (no error code), except now the askoll type wash pump is noisy and knacked. I will go back to fit a new pump, and do what you suggested. Thanks again
Graham
Re: hotpoint ctd 00 leak
To clean the back of the condenser housing it’s easy to do it with the side panel removed. Much better than lying on the floor.
Re: Whirlpool Commercial Toploader
I have fitted a clutch a few times on these machinrs p/n 481969018152 to cure a slow spin. It has always cured it
Re: Pat test failed,What mega reading do i need
Excellent reading garn
I found this which might help anyone
Re: JTM again!
Thanks jess1ca
A strange set up. So are you saying it’s not worth taking on jobs for the hassle involved?
jess1ca wrote:but make sure you get the parts back for credit if the jobs are closed down
Are you saying they charge the repairer for spares, (instead of sending them FOC ), so they can then be charged back with a mark up?
Graham
Re: JTM again!
Had a phone call today from JTM asking me to do work for them. Did a search and found this thread. After reading it I don’t know weather to say yes or no. Are things still as bad doing work for them, or has it got any better?
Graham
Re: Numatic NVQ 250B motor
I think the new motors are smaller, and you have to fit a larger rubber mount to make it fit.
