Forum Replies Created
-
AuthorPosts
-
Specialist01269
ParticipantRe: Whirlpool AWZ2303 Not heating up
Have you checked the Element for continuity?
Specialist01269
ParticipantRe: samsung de-frost heater
Can you enlighten us some more? you have’nt given much information for anyone to go on.
March 6, 2011 at 1:20 pm in reply to: Electrolux EOB5600B oven not heating yet grill works fine! #345838Specialist01269
ParticipantRe: Electrolux EOB5600B oven not heating yet grill works fin
Hi: if you take a look at item number 14106 in the UKWG Shop, it’s the 1 listed for your cooker & at quite a good price.
Specialist01269
ParticipantRe: Hotpoint WMA63 Chopper board resistor failure
Count yourself lucky, on the occasions that these boards do blow it’s normally a lot more serious than you experienced.
Specialist01269
ParticipantRe: Indesit IDL40S – burning smell & overheating?
Hi: If you are concerned with the safety of the machine then I would not use it until it has been checked by an Engineer, the darkening of the Element & burning smell could possibly be due to the Element overheating.
Specialist01269
ParticipantRe: Hotpoint TDC62 Stops after a few minutes
There is a third stat above the door which can also fail, but you may well have a fault in the notorious Dryness module. As far as I know there is no one that repairs these modules & they are pretty expensive to replace £100 – £120 depending on where you buy.
Specialist01269
ParticipantRe: Seriously….no buyer is this stupid!!!!!
Martin, You old cynic 🙂
Specialist01269
ParticipantRe: Seriously….no buyer is this stupid!!!!!
Last 1 I bought was about £4.95 trade.
Specialist01269
ParticipantRe: Indesit Washing Machine explodes!!!
Wonder how long before someone gets injured? hate to think what would happen to a child in front of 1 as it explodes.
Specialist01269
ParticipantRe: Siemens tacho reading?
Aww Jim it’s only a little bit out, don’t be so picky 😆
Specialist01269
ParticipantRe: Seriously….no buyer is this stupid!!!!!
Just gotta have that, 😆 bet you some idiot will buy it.
Specialist01269
ParticipantRe: Hotpoint WT540
Glad to hear it, what was the colour code on the valves after?
On the WT540, check the motor connector is seated properly, check motor brushes, check for breaks in the motor harness.Specialist01269
ParticipantRe: Hotpoint WT540
What Happened to your Indesit?
Specialist01269
ParticipantRe: Bosch SGS43A52/35
Yep they can be replaced, can be done DIY but even easier if you have Hot Air re-work station 🙂
Specialist01269
ParticipantRe: Howdens Kitchens
😆
-
AuthorPosts
