Forum Replies Created
-
AuthorPosts
-
spimps
ParticipantRe: Zanussi ZWF1221W
Am getting 4 falshes ie press the start button then end light flashes 4 times !
BGSeptember 30, 2009 at 9:21 pm in reply to: Fridge wont work but freezer does!! Diplomat APM6855 #297732spimps
ParticipantRe: Fridge wont work but freezer does!! Diplomat APM6855
Don’t forget the fan doesn’t cut in until the evaporator temperature is down to -12c which could take up to 10 minutes.
Plus did you clear the channels through which the air travels to and from the fridge.spimps
ParticipantRe: Zanussi ZWF1221W
Will check the flashing lcd’s tomorrow,product no is 914215103(01)
September 29, 2009 at 4:40 pm in reply to: Hotpoint FFA52 Ice forming in freezer **Solution?** #290794spimps
ParticipantRe: Hotpoint FFA52 Ice forming in freezer **Solution?**
Shame that companies don’t field test stuff before unleashing them on the market,they are in such a hurry to market stuff basic design isn’t good enough to give a decent trouble free product.Plus,engineers are struggling too,they are at the sharp end doing thier best,not to mention the customer who has paid out in good faith and ends up with a second rate product and tons of hassle.
Interesting thread,hopefully you will have a better result next time.spimps
ParticipantRe: Britannia cooker? info
maltheviking wrote:
spimps wrote:
Think this(beneath the grease 😯 ) is a Britannia ckr model
SI5-TB-GRA-BR – ART -JPD90 NMP are what is on the plate.
Anyone help or have any info please?
mixed fuel ckrI think Britania are based in Blackpool mate, try this link
😉 http://www.britannialiving.co.uk/THKS
BGspimps
ParticipantRe: Hotpoint FFA74 – fault-find assistance required
Depends on the contents of freezer and ambient temp.At the rate it has dropped so far would expect it to be -20 ish in the morning.
spimps
ParticipantRe: Hotpoint FFA74 – fault-find assistance required
The defrost cycle is usually automatic ie approx every 6 or 10 hours depending on make and model.
Later ones have a sensor which monitors frost and then activates defrost, but I think yours is pre that.
What actual temperature is the freezer achieving?spimps
ParticipantRe: amica f/f ak311
Over the years yes,on many makes.Think LEC were prone to it.
used to find them wrapped in their own little plastic bag to stop the condensation.spimps
ParticipantRe: lpr600 dishwasher
Think thats the most likely,had a couple with similar which turned out to just that,a good clean and they were OK.
spimps
ParticipantRe: Hotpoint ffa70 not working
Sounds like compressor which could be close to £200 to repair.
spimps
ParticipantRe: FF72P Baffle
If the sensor fails it automatically leaves the baffle open,hence the freezing in fridge.
Very small baffle motor can’t see any readings for it.
Sensor is 2600284September 24, 2009 at 6:52 am in reply to: Integrated Ariston Fridge Freezer is not cold enough! #297757spimps
ParticipantRe: Integrated Ariston Fridge Freezer is not cold enough!
Sounds like you have possibly a refrigerant loss,probably worth thr gamble on an engineers visit.there is a search facility
.here for your nearest one.spimps
ParticipantRe: FF72P Baffle
Fridge thermistor controls the baffle via the board so thermistor should read @20 c room temp 3k.
If you need a diagram pm me.
BGspimps
ParticipantRe: Samsung SR2229CVW Defrost problem….
You said fridge fan is working,is the freezer side one working?
September 18, 2009 at 9:19 pm in reply to: Whirlpool ARC7410 Fridge/Freezer – Not switching on?? #297397spimps
ParticipantRe: Whirlpool ARC7410 Fridge/Freezer – Not switching on??
Could be the bi metal stat part no 481228228281
-
AuthorPosts
