[subs]

Re: Indesit Bearings

Thanks for every ones help. Turns out to be 22mm bearings i need so your input steve helped me right out, ive got a few hotpoint bearings on the van just need to get the seal cheers.

Subs 😀

[subs]

Re: Resetting Hotpoint FDW80

Thanks for reply Jim! I tried resetting machine with the float switch disconnected, i get the dashes come up but after a few seconds the pump just kicks back in again. I don,t want to replace the wash pump until i know its that for sure,and i can reset the machine

Subs

[subs]

Re: Indesit Bearings

Cheers Richard! Its the external spider one, i did one a while back and it was a bit of a pig so this time i quoted the landlord top dollar, not fancying it and he still went for it 🙂

Subs

[subs]

Re: Bosch pattern part

Thanks Andy 😀

[subs]

Re: Hotpoint WF545A

Thanks Jim!

Subs 😀

[subs]

Re: Zanussi Washer

Thanks for that steve! Ill check it out.
Subs 🙂

[subs]

Re: Ariston fault code?

From what i can decipher from the error codes for this machine, the first LED flashing along with door lock light is a F08 heater relay fault.Can anybody confirm this please.

Much appreciated

Subs

[subs]

Re: Ariston fault code?

Thanks Chris

Subs 😀

[subs]

Re: Bendix washer still no heat

Much appreciated Chris

Subs 😀

[subs]

Re: Bendix washer still no heat

Does not seem to be anything in my inbox Chris

Subs

[subs]

Re: Electrolux Frost Free Mod No:- ER 7626

If the heater comes on when you advance the timer to the defrost mode then i always just melt ice and replace timer.
Solves problem everytime. 😉

Subs

[subs]

Re: Attractive Blonde

richardable wrote:why do women of any age, size, looks etc say….i’ll be upstairs if you need me?…or can i hold anything for you?

😆

Or “just give me a shout if you want me”:lol:

[subs]

Re: Creda dryer getting too hot?

Its probably going to be one of those senarios where the cus has had the machine for two years and never took no notice of it but since its been fixed has sat there watching it and noticed things they hadnt before (Like, gets quite hot) :rolls:

[subs]

when the hose is recrimped will the seal ok again as the dont seem that tight you would think with the pump pressure the would blow off.

Ive had a lot of trouble in the past with these crimped bands until i discovered from a car spare shop, metal bands that work just like pull ties and are ideal in situations where jubilee clips are either not big enough or too thick.
😉

Subs

[subs]

Re: Ariston chucking water out of soap drawer

But i had the waste hose off the trap and into a bucket and the water was coming out thick and fast once the pump kicked in, on every time i tried it.Surely the only difference between a light spin and normal spin should be the speed and duration. 😕

[Author]

Posts