Forum Replies Created
-
Posts
-
Re: CDA Dryer Element Obsolete?
Thanks for your help Jackal.
Who are JTM? Do you have their number?
This job is for a letting agency and they would rather repair it rather than replace it as its an integrated. Even if its a bit expensive.Subs
Re: Beko Condensor Dryer DRCS68W Cutting Out
Double checked everything on this machine. Condensor clicked in correctly, float chamber empty and float switch working correctly as is the pump, even tried new capacitor on motor. Put machine in test mode and heaters and pump comes on but motor does not. Insulation test on motor ok. Strange that the motor runs for a few seconds and then stops.
Subs
Re: Bosch SMS40A08GB/01 D/W A few questions.
I went back to this DW and the base was flooded again. The leaks i fixed before were ok. I noticed that there was also a slight leak at the back where the steel cabinet joins the plastic base ( some water was splashing over the joint and running down the back and could find its way into the base.
Now the reason i asked the question about what specificly E14 meant was because the only fault i found was the leak. Im not sure there is a fault with the flow meter because when i tested the reed switch with a magnet and meter it worked, (although i did notice that the reed switch was normally closed circuit and open when i placed a magnet near it) is this correct? The reed switches i carry on the van to replace on the whirlpool flow meter is opposite.
Also while i was there i ran it through a 30 minute quick wash and it went right through ok.
ThanksSubs
PS
I have removed the cabinet to replace motors and heaters on the old Bosch DW’s hundreds of times but was just wondering if this version had anything to be aware of that was different.Re: Ikea Whirlpool DWF415S Product code 854541515710
Ive had a couple of whirlpool dishwashers where when it tries to fill with water the water valve pulses on and off. Cant remember what models they were but they were the ones with the module in the base behind the front plate. Replacing the board cured the fault.
Subs
Re: Bosch WAE24467uk Dead
It’s completely dead, no display nothing.
I have live from mains filter to board and back through the neutral but nothing else at all.
