Forum Replies Created
-
Posts
-
Re: Non working Hotpoint ultima TDC62
i think its orange and orange blue to the left stat i dont think the wires are long enough to put them on the wrong way.
i am however breaking forum rules by tellig you .
plug out first.Re: BWD 129 door locked light flashing
i would expect it to be the motor brushes plug out if checking.
Re: Indesit WIDL 126 Flashing lock light
you may have knocked the wires off the door interlock plug out if checking.
Re: WMS38 (Hotpoint) – Blocked powder downpipe?
t sounds like a blockage in the hose take the lid off and then take the hose off, or remove the outer lip of the door seal and take the end of the hose off the drum, its posssibly blocked with soap powder or a foreign object.
plug out of course,and while you are at it see if it has a filter behind the plastic kickplate take it out and clean it.
Re: WT741 Stuck on 01 minute
i think its the heater you could try disconnecting it to see if it makes a difference.
Re: Zanussi Washing Machine module
i assume reading out of range means there was a short somewhere,
you cant check a door interlock for shorting.but a heater can give a different reading when in water.Re: Washing machine help.
its not a capacitor its a suppresor, you will have blown the triac on the pcb, if you look at the main pcb you will see a blown triac its more obviuos if its the 3 legged variety less obvious if its surface mounted.
i would say plug out first but you must be lucky not to have electrocuted yourself the first time round.Re: Zanussi Washing Machine module
trace the wires back from the burnt component will tell you what has blown it. normally heater, door lock or motor.
you should have found out what had blown the original board before putting in a new one.
plug out of course.
