[suedehead1]

Re: bosch wae3246gb/01

thanks cutomer has just told me its working ok now?

[suedehead1]

Re: hotpoint wd 420

if they are flashing rapidly its the pcb you can get one from emw.

[suedehead1]

Re: aeg dishwasher

thanks for the reply out it comes then.

[suedehead1]

Re: AWZ410 Whirlpool

its always a good idea to check carbons and heaters on these whirlpools,
if you have done that its most likely to be the timer.

[suedehead1]

Re: Hotpoint WD865 – Faulty buttons

Suggestions?
leave it alone choices are overated one program required non fast 40 and wash everything at it, in the old hoover days it was program E, demonstrating operation to the elderly could not have been simpler,
E for everything.

[suedehead1]

Re: Indesit WIL 153

if it switches itself on its the pcb try emw.

[suedehead1]

Re: Whirlpool ADG710 WH/2 Stuck in Cycle

i am sur it has a resetable thermostat if the heater is visible in the bas of the dishwasher the thermostat is visible under the heater it is round chrome, under the base will be a black plastic thermostat with a red button in the middle.

[suedehead1]

Re: neff s5443x2gb/17 dishwasher

thanks for the reply i might send it to qer for repair although i havent had many good experiences with them.

[suedehead1]

Re: neff s5443x2gb/17 dishwasher

i took the pcb off but the tracks and relays looked ok,

[suedehead1]

Re: Whirlpool ADG710 WH/2 Stuck in Cycle

if it has a reset it wll be on the thermostat under the bottom of the dishwasher,it will have a red button and will be near the edge of the dishwasher normally at the lef hand side.
you could see it if you take of the front panel,you must take out the plug first.
if it has a red button reset if yu push it it will make a pronounced click if it needs reset.

[suedehead1]

Re: Indesit WD12X – multiple problems

you dont fix it you replace it.

[suedehead1]

Re: Miele W827

remove a couple of screws at the bottom behind the kickplate and 1 or 3 bolts round the outside of the door seal, remove outer lip of seal and cuple of screws in the door lock and the front opens up on a hinge at the right hand side,
if its leaking there is a float in the bottom it could be the door seal or the filter not in tight enough.
(from memory)

[suedehead1]

Re: Indesit WD12X – multiple problems

sounds like a job for an engineer.
try repairs@

[suedehead1]

Re: hotpoint washer WF3200

had one last week board fault got one from emw sorted it out.

[suedehead1]

Re: Non working Hotpoint ultima TDC62

i forgot to say green spot stat to the left.

[Author]

Posts