Forum Replies Created
-
Posts
-
Re: Bosch KGU 3201GB/01
E2 is rear wall sensor faulty, foamed in so unable to replace.
New pcb needed 263782 about £130.
Re: Bosch SGS53C02GB/08 Fault
If it cycles fill/empty constantly more than likely gonna be the flow meter (impellor jug) part no. 424099 about £11 if memory serves 😉
machineman wrote:no pressure is good.how do you define low inlet water pressure these are cold fill only.m
Kinked inlet hose maybe, duff washer tap or even one of those awful self piercing valves.
Re: Bosch SMS5032GB/11 dishwasher door loom cut
You’ll probably find that it will be a universal loom anyway.
Which will come with Gegsy’s ferrules attached 😆
Re: Bosch SGV4313 Detergant not dissolving
What programme are you running ?.
Cos if it’s heating, circ pump is running and the water levels are ok there is’nt much left that can cause the problem 😕 .
Re: Bosch SGS45EO2GB/45 fault.
I’m 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure that will cure your fault 😉
Re: Bosch SGS45EO2GB/45 fault.
It’s an in line flow meter and as such sits in line of the water supply.
Re: Bosch Module 264877
mjhservices wrote:You do not code this module
Oh yes you do, some of them have a coding plug fitted to the original PCB. IIRC it sits on the rhs of the board.
If there was one fitted it MUST be fitted to the new one too.
I hope you aint binned the original :rolls:
Re: Neff Combi m/w
More than likely it will need a new inverter PCB and mag.
Did one just the other day for same fault. Guess what though it aint cheap.
Re: Neff Dishwasher S5443x1gb/12 dead
IIRC mains from on/off s/w goes straight into pcb I think it’s a black and grey wire.
The red wire that is also in the same connector block is the feed to the heater via the overheat stat.
HTH
