Forum Replies Created
-
Posts
-
Re: Bosch WVF 2402GB/01 FD 8306
Yup WVF has a constant flow into condenser.
There should be a restrictor fitted in the valve itself. If memory serves I think it’s a small red piece of plastic.
HTH
Re: Dishwasher crisis!!! please help, hands getting very dry
I would suspect you have a broken wire or wires in the wiring loom.
The only solution is to replace the complete wiring loom.
:plug: power off and plug removed if you’re having a look :plug:
Re: Will the Miele last with 3 kids?!
Normally a machine with a 1600 spin will probably only spin at 1600 for the last two mins of a spin cycle at most.
My m/c has a 1600 spin, but I ALWAYS reduce the speed to at most 1200, because as Kwatt pointed out the amount of creasing at 1600 is ridiculous. And I don’t like to see the missus struggle with her ironing 😉
Re: Neff 6544 – Door boot
You need to remove the m/c from the housing.
On the rating plate on the back will be 6544 followed by either a couple of numbers or letters if memory serves. These make all the difference to the parts.
Re: NEFF INDUCTION HOB T4243X0
dna wrote:HI I FORGOT TO MENTION THAT THE CUSTOMER SAID THAT THE HOB WAS OFF AND IT TRIPPED THE ELECTRICS???? HAVE TAKEN THE HOB GLASS OFF AND TRIED IT WITH IT OFF BUT NO JOY.
😯 😯 You haven’t put a pan directly on the hotplate have you 😯 😯
BTW is it not still under it’s 2 year guarantee?.
Re: Neff B1322N1GB oven installation question
Will be fine on 13 amp plug, unless installation instructions say different.
Max load will be roughly 11.5 amps 😉
Re: Bosch fridge freezer error code
I would suspect it would be a KGU.
E2 is rear wall sensor failure, it’s foamed in so a reworked PCB will be required. If it’s the frost free KGU then 263782 will be needed.
Without full E-Nr it’s guesswork though :con:
Re: Bosch DKE995AGB hood – no lights!!
aqualectric wrote:I found the fuse and it tested out OK. 😕 So I am assuming it’s the PCB at fault. There is no power supply to the lamp transformer and the fan sometimes hums when switched off.
Weird thing – and a joy to dismantle – NOT!!! Brand new induction hob directly beneath….gulp!!!Thanks for the input. If you can help some more, it would be greatly appreciated.
Steve.
Have know the pcb 264223 supply low voltage to motor in the past. Not cheap to replace though :rolls: .
Re: Bosch WFK2200 My bleep’s come back
If you’re feeling strong, pull the m/c out and there will be another sticker with the E-NR on the back 😉
Re: Knocking sound at low RPM from Bosch Logixx 1400 Express
I find the shockers VERY reliable, I have only ever changed two sets 😯 .
And on both occasions it was the rubber bush that had given up not the shocker itself.
Usually I find that knocking noises tend to come from poor loading issues rather than a fault with the machine itself. Most peoples idea of a full load is often more like two full loads, or they are trying to wash a single bath mat :rolls: .
Re: bosch sticking on 36 mins
SHAKEAPAW wrote:i put the nozzel of the hose into the filter area and then “blasted” the water through,i also think being a dishwasher,its pretty waterproof when “blasted” with water from the inside.
It’s the turning it on it’s side that may do the damage, as much as the “blasting”.
Definately not recommended.
