Forum Replies Created
-
Posts
-
Re: Bosch WVF2000GB/34 washer/dryer drum bearing kit needed
Hope you’re ready for a hard slog.
Bearing job on that m/c is not very nice 😥
Re: bosch dryer 3204gb
Depending on model,m/c does not pull full current for at least 5 mins.As comparison is made between ntc’s.If you disconnect one then it will show fault.
Have you checked carbon pick up on rear bearing?
HTH
Re: Bosch Maxx WFO2466 sticking on programme
Fault codes are displayed via wash,rinse and spin lights as a rule.
Normally if it aint taking conditioner,the holes in the dispenser tray are blocked with gunge.A cable tie poked in these holes usually sorts that problem 😉
could be a faulty door lock,as they just unlock approx 2 mins after end of prog,even if there is water in drum
Re: NEFF B1441
Job can be done fairly easily and quickly(when you know how).
Unfortunately we can’t go into detail on here for legal reasons.
Time to call someone out methinks 😉
Re: NEFF B1441
Probably just needs hinges,TBH.
No need to remove oven from housing for this.
See manual as to how to remove door.
Power off first,just in case.
Re: bosch sgs53co2/gb stopping near end of wash cycle ????
There is a modification kit available for snapped heater clip.
Definately not a scrapper. 😆
Re: candy alise 105 changing bearings
Who’s gonna offer to send a free of charge big ,huge,massive mash hammer to Finland 😆
Re: Guess who’s back.
He’s certainly persistent!!!
What is it with some people,they ask advice then ignore everybody telling them to scrap it.
Re: Bosch DW Sgs43t22gb/01 Intermittent fault
Does it fill/empty at same time?
If so check for grease and metal filings around magnet.Clean these off and the chamber where magnet sits?
If all these ok,I had one the other week with a duff module,worked fine on all cycles,except quickwash.
HTH.
Re: Bosh WFF2000
If motor and tacho are ok I would say yeah it’s the board.
Assume there are no earth faults on m/c.
Re: Bosch SGS 6312GB/07 Pumping continually
Probably the PCB if there is a dot in display.
Do a search there are many posts about it.
