Forum Replies Created
-
AuthorPosts
-
Taff
ParticipantRe: BEKO DCU8230 Sticks in program
When any of the cotton or synthetic programmes are selected it consistently heats and turns and the cloths are tinder dry. I will ask the customer to reuse the machine to confirm if there are any flashing lights.
Taff
ParticipantRe: BEKO DCU8230 Sticks in program
The machine just consistently heats up and turns sticking in its program. The only program that will stop is the timed programs.
Taff
ParticipantRe: Fischer Paykel Dishwasher 2 Draw
Went back to check this machine as it was bugging me. One of the two drain hoses was blocked with fat. Strange how only one was blocked at the Y Connector.
Taff
ParticipantRe: fisher paykel dishwasher
Any chance you can email a manual for these dishwashers please. keith@hillcrestservices.co.uk
Taff
ParticipantRe: AEG L14710VIT Washer Dryer
I can see the water flowing from the water valve into the condensing chamber? The small chamber to the rear of the soap dispenser is clear and when I take the top off and run the machine water is injected in to the plastic tube that is connected to the condensing chamber.
Taff
ParticipantRe: Indesit DIF04
I will double check tomorrow.
Taff
ParticipantRe: Siemens Dishwasher SE64A630GB50
I disconnected the solenoid for the regeneration valve and this seemed to solve the problem so I will replace this and retest. The regeneration valve is the last item to operate on completion of the program.
Taff
ParticipantRe: Miele PW6055 Plus LP washing machine
I’ve has two Miele’s recently with the same problem. I sent both boards to QER for test/repair. Both came back with the main chip blown. Both machines scrapped due to cost of boards. Main problem being that a fault could exist on the machine which caused the board to blow, fitting a new board could cause the same fault on the new board.
Taff
ParticipantRe: AEG L12710VIT Drying Cycle No Heat
I will revisit, what should the readings be? Thanks for the reply. Taff
December 14, 2012 at 3:22 pm in reply to: Neff Built in Oven B4562NOGB/02 FD8902 00024 Error Code 15 #385412Taff
ParticipantRe: Neff Built in Oven B4562NOGB/02 FD8902 00024 Error Code
Found out from Bosch after 5 days that this Fault code is Quote indicative of the door lock operating at a temperature above 350 degrees C. I bypassed the job and even the Bosch engineer had to get technical information to cure the fault!!
May 20, 2012 at 7:21 am in reply to: Whirlpool AWD/R 4205 Check Water Check Filter Lights on #375190Taff
ParticipantRe: Whirlpool AWD/R 4205 Check Water Check Filter Lights on
Model is definatly AWD/R 4205
Taff
ParticipantRe: Bosch Dishwasher SGS43T52GB16 Check Water Light
Yes the impellor jug has an arrow indicating direction of flow.
Taff
ParticipantRe: CDA WC420 Dishwasher
Many Thanks for your assistance. Regards
Taff
Taff
ParticipantTaff
ParticipantRe: Lamona Washing Machine HJA8514
Customer has given up and bought a new machine. I will pick the old one up and I will find out whats wrong this blasted machine. Like a dog with a bone!!!
-
AuthorPosts
