Forum Replies Created
-
Posts
-
Re: Zanussi ZWF1221W
How many flashes of the end LED do you get before the flashing pauses & restarts.
Also, do you have the product number beginning 914?
Re: Tricity Bendix DH200 not heating water.
Most likely the triac on the main board has popped. Unless you are handy at soldering, it will require replacing. If you do require a board, the part number is: 1528245507.
Obviously, please isolate appliance from mains electric supply before any work is carried out on it.
Re: AEG S756281KGS
I have to be honest, that is not something I have encountered myself so cannot answer if that is normal or not. Sorry I can’t help on that one.
Yes the bottom board is under the front grille.
Re: Tricity Cooker 1637
It could be but there is a digit at the end that I can’t make out but when it goes into the Electrolux Distripart system, it fills in the blank so that may be why your suppliers don’t recognise it.
Re: AEG washer / Dryer L 16810
Hi.
Yes, this can be programmed manually but as I know of even trained engineers cocking it up I would not want to put you in a position where you make the situation worse, even if you believe that is not possible & are confident in your ability.
My best advice to you would be that as you are not certain that the board is even at fault, that you contact a local qualified recommended tech, possibly your local Serviceforce, who will be able to assist.
Re: Tricity Bendix DH909 no finishing
Isolate appliance from mains electric supply, turn off water, disconnect inlet & outlet hoses, put down floor protection, lay appliance on its back, take off U shaped tube, clear through it & sump spouts & refit, note pressure hoses location, remove & blow down them & refit where they came.
re install & test.
Re: AEG S756281KGS
That is the fault code for a faulty evaporator ventilator (fan). There are 2 PCB’s in the dispenser unit, one under the product & one in the fridge.
Re: AEG washer / Dryer L 16810
Not a reset but the board has to be configured for use with a 16 digit hexadecimal code specific to that machine. Some are configurable in the field but not all can be.
Do you have the product number beginning 914?
Re: Tricity Cooker 1637
I think you may have some luck with Part Number: 57249670400. I don’t have a diagram, just a description on TDS Online. It an old Tricity Contessa, Yes?
Re: ed4 – new zannussi/electrolux W/D
Just a few screws & wires to disconnect & the duct comes away with ease.
It will almost certainly be the dry heater. I work for Electrolux Serviceforce & I have been fitting these like the are going out of fashion. Any reading below 10 MegOhms & I would change it. If it checks out ok, run it on tumble dry for 5-10 minutes & retest the heater & see what you get.
Seems to happen if customer seldom uses drier.
Re: Zanuzzi Freezer ZUF105W (frost free)
Always possible but not likely. I have had this on more than one occasion & it’s usually the NTC.
Re: Beko WMA510 wash led lights on spin
Hi Bernie.
Is there any laundry in the drum? If so, it could just be an unbalanced load but if not, yes the board is certainly a prime candidate. I have had several fail like you describe where they just tumble, try to ramp up speed but don’t actually spin & it is usually the board. If you need it, the part number is: 2822640073.
Hope it helps.
Best wishes.
