Forum Replies Created
-
Posts
-
Re: AEG Lavamat 76810 motor or control problem?
Hi.
It depends. Do you have the product number beginning 914?
Re: electrolux ewx14440w 914602300/00
Hi.
Check the drier heater. If diagnostic has Ed4 as last recorded fault code, change said heater.
Re: Zanussi fridge-freezer fridge getting warmer
Hi.
With all due respect to Seamy, I think he may be thinking of a more recent range of products which have given problems. Your one is from a range known to the trade as Eurocombi.
Re: Zanussi fridge-freezer fridge getting warmer
Hi.
Eurocombi this one. It will usually be an open circuit defrost heater or an out of calibration temp sensor. If you have a suitable test meter you can test the heaters for resistance which usually is around 200-250 Ohms observing all safety precautions first. Should that be ok, it will be the sensor.
Re: Zanussi 1250 Turbodry
Hi.
Take out drawer. Towel on floor. Unravel paperclip. Turn timer to where conditioner rinse starts. Whilst it is filling, prod paperclip into both jets which are above conditioner compartment.
Sorted!
Re: Zanussi ZWF12070 stopped mid cycle
Hi.
If you have checked the obvious, I suspect the board has died, most likely cause is a duff door lock which if you look at carefully & see brown marks on it will give you a bit of a hint.
Re: Bearing replacement on Zanussi FJS1397W
Hi Vince.
You will also need to change the drum shaft spider.
