Forum Replies Created
-
Posts
-
Re: HOOVER ACM15
Could be pressure switch stuck in safety mode. Check wiring to switch as well, maybe you disturbed the wiring whilst cleaning the detergent tube.
Re: hpt 30mm bearing kit
Homespare do a genuine kit for £17 plus VAT. (bit of a saving).
I suppose as always its not too difficult getting the right bearings but its the seal thats critical.Re: hoover dryer HNC175
Maybe the shaking happens when it reverses. Normal culprits are the pulleys. front drum support ones more so than the tension pulleys.
Re: Zanussi ZJ1217
Right here we go……….
when you turn the selector the leds light as they should.
when you press start the door clonks three times. then the second and eigth light flash. (leds 2 and 8). Now if i have worked this out correctly this is error 41 door problem?
I have tried to put it into diagnostics mode by doing the start and one option button pressed while turning selector once clockwise. I cannot get it to go into diagnostics.
Do you think this is just a door interlock problem or board fault.
I have checked all wiring and insulation tested the machine, all ok.
Thanks.
Re: Zanussi ZJ1217
Great. Finally feel like I’ve got somewhere. 😀
Thanks Martin for your ‘maze’ like guidance. 😉
Thanks Brian for your suggestion about the edge connector. Lets hope its just that. Nothing like being prepared though.
Cheers.
Re: Zanussi ZJ1217
Have you ever looked in the sticky in this forum “Known Error Codes?”
Yes thanks.
The only Zanussi codes I can find relate to the “EWM1000” pcb.
Are these codes and test procedure the same for the
EMW2000
PCB?
Re: Zanussi ZJ1217
Just suss out those error codes etc etc and away you go!
thought that might be the case.
As i am going tomorrow and have no TDS disc can you tell me how to access the error codes and what the error codes are?
Thanks.
Re: Samsung B1245S washer
Changed a few dispenser carriages and draws for that problem. (Could try turning water pressure down a bit first and winding the front feet down).
