Forum Replies Created
-
Posts
-
Re: diplomat intigrated w dryer
If its the same design as the servis old machines then undo clamp and use three molegrips. Starting at the 6 oclock position put one molegrip and then the other two at three oclock and 9 oclock. This will allow you to tighten the bolt alot more!!!
If this dosen’t work change the tub gasket and tighten as above.
Re: hoover pe235 washer
9/10 timer, 1/10 main module.
Thats assuming the heater isn’t low insulation or pump open circuit.
If you search pe235 and timer, or hoover and timer, theres plenty there if you need it.
Re: CDA CI993 door staying locked when half load is on
That two minute wait is normal isn’t it?
Can you get the manual for it?
If it isn’t normal you have to start by changing the lock?
(Long shot but do try plugging it in another socket)
Re: CDA CI993 door staying locked when half load is on
Do you need to have the half load button pressed in to get the dryer to work?
Re: Candy Washer Dryer – CMD 146
Overloading? Un-even load?
Belt stretched?
Drum bearings wearing?
The fact that its that in-frequent I would say its a loading issue.
Re: indesit di620 d/w
I’ve got one of these to repair.
The fault is the same no heat.
I’m reluctant to repair this one because the customer says the machine has never heated from day one. They had indesit out who said there was nothing wrong.
I’m ordering a new board for it, as everything else rings out ok, but have got a bad feeling about it.
If you can get the truth out of your customer maybe the scenario is the same??
Re: Hotpoint dishwasher DF23
Clean out the black sump hose.
If that doesn’t cure it replace the valve assy.
Don’t think theres anymore to it than that?
(For testing purposes you can slave in a normal single valve.)
Re: Siemans WI144S440 GB/06
If you search ‘Bosch and F17’ it comes up as valve related problems.
Fill time out or open circuit coils.
Re: servis pcb
Yep got one. It looks untouched so should be plug n play!
I’ve sent you a PM with my mobile, so you can give me your address again.
Re: Hoover TC650
I’ve mentioned it a few times that you can pop inwards the ty-wrap at the back and pull the connectors through the grommet area. You can with a fiddle pop the stud of the ty-wrap back in as well. Silicone up the grommet and jobs a good-en.
