Forum Replies Created
-
AuthorPosts
-
Tony R
ParticipantHi Tony, If the interior light is flashing on and off, I would suspect the integral board is malfunctioning.
September 3, 2019 at 6:05 pm in reply to: Liebherr Fridge Freezer CUN 3523 20M Error Lights Flash #462984Tony R
ParticipantHi Rob, there are 2 sensors in the fridge air (red ) Evaporator ( green ) you will need part 9590206 and replace the green one with the kit, it can be bought on Whitegoods parts site.
September 3, 2019 at 8:18 am in reply to: Liebherr Fridge Freezer CUN 3523 20M Error Lights Flash #462981Tony R
ParticipantHi Rob, the refrigerator evaporator sensor has failed.
August 28, 2019 at 4:58 pm in reply to: Liebherr Fridge Freezer CUN 3523 20M Error Lights Flash #462978Tony R
ParticipantHi Rob, what number is the green block flashing with the superfrost ?
Tony R
ParticipantThat’s because when you reverse the door to make it open from either left hand or right hand,you don’t turn the door upside down.
Tony R
ParticipantRemove the stainless steel cover in the lower cooling zone,by removing the screws, the drain hole is on the left hand side below the cooling plate, insert a cable tie down the hole to clear any obstruction. Liebherr WT4677 index 20C-001
July 30, 2019 at 5:39 pm in reply to: Liebherr fridge/freezer cunesf3503 – fridge not working #462548Tony R
ParticipantI hope you did not push of the black rubber drain valve with the brush, it is very important that it is in place, as there will be direct air entering the drain and will give you further problems.
July 24, 2019 at 7:50 pm in reply to: Liebherr fridge/freezer cunesf3503 – fridge not working #462546Tony R
ParticipantI would try an extended defrost for a least 3 days, longer if possible and check to see if the drip tray fills up with water the tray is situated on top of the compressor, most frost free units can suffer from a blockage in the freezer drain, this causes an ice build up in the freezer. if it fills up then that was your problem and it should be then good as gold.
July 23, 2019 at 8:31 am in reply to: Liebherr fridge/freezer cunesf3503 – fridge not working #462544Tony R
ParticipantHow long did you do a defrost for, if overnight it may not have been long enough, is the fan working in the freezer, are you getting frost forming on the interior rear panel in the freezer, without more info its impossible to diagnose your issue. The system will concentrate the cooling to the freezer if it is too warm and this will affect the cooling of the fridge section unless its powered off and electronics will reboot but revert back to main freezer cooling. PS we always need index or service numbers to identify your exact unit.
July 13, 2019 at 6:15 pm in reply to: Liebherr CUN 3033 Works fine but beeps while number 3 and superfrost button flash. #462018Tony R
ParticipantPrinted on the original sensor will be the part number for it, but as the new sensor comes in a kit with junction box and 2 crimps it will have a new part number, if you have got a 9590206-00 you have the correct part to repair.
July 10, 2019 at 8:20 am in reply to: Miele K 8652 SD fridge, deadish, give up or investigate? #461763Tony R
ParticipantJust looked as there appears to be differing part numbers depending on the index number, if you can provide this I will recheck, it will be something like 164-20A, the buttons will then match with the board.
July 10, 2019 at 8:13 am in reply to: Miele K 8652 SD fridge, deadish, give up or investigate? #461762Tony R
ParticipantLiebherr PCB, 6133696 is listed at £81.05 plus carriage and VAT and in stock, have you tried obtaining it on this site ?
Tony R
ParticipantHi Paul, I believe the control knob part 7424088 is levered off with a flat blade, the trim can also be removed the same way starting at one end, but should not need to be removed to replace control knob.
June 13, 2019 at 7:56 am in reply to: Liebherr CUN 3033 Works fine but beeps while number 3 and superfrost button flash. #462014Tony R
ParticipantHi Enofi,
You need a new evaporator sensor in the fridge, get the repair kit on this site part 9590206.Tony R
ParticipantThanks Tim, I am glad its all working fine now, and no need to keep it a secret that I was the Engineer, in both cases.
-
AuthorPosts
