[Washman]

Re: BEKO D533 – Main oven not working

Hi

If the fan and light are working the element has failed.
replace element.

Washman

[Washman]

Re: rca washer

Hi

Its an American made machine ( RCA )

Washman

[Washman]

Re: Siemens Washing Machine WXL 120GB/01 How to remove top

Hi

Undo the screws at the back and slide lid towards back of machine ..\do not remove weights.

Washman

[Washman]

Re: Servis Heater Element

Hi

Try http://www.awsappliancespares.co.uk and http://www.hygenadiplomatspares.co.uk
tele no 01603 412324

Mike

[Washman]

Re: whirlpool adg 9573 – position of ntc ?

Hi

How did you check the NTC is at fault if you do not know where it is.

Washman

[Washman]

Re: tangential fan motors

Hi

If you go to Masterpart then cookers then motors on the first page there are about 4 listed

Mike

[Washman]

Re: How to remove programme selector knob?

Hi

Model number and PNC number would help.

Washman

[Washman]

Re: WHIRLPOOL GEARBOX

Hi

Part no 481903949118 out of stock Masterpart and Connect.

Mike

[Washman]

Re: W/pool dishwasher ADG7560/1 fills, then drains, then sto

Hi
7 flashes is flow meter fault

Washman

[Washman]

Re: Beko wm 8127w not finishing cycles

Hi

If He is that technical then he should be able to find the fault, most of the people here that reply to your questions are Engineers so your comments are quite rude to them.

Washman

[Washman]

Re: how do I replace a broken plastic hinge on bosch dishwas

Hi

Full Enr requiered please to help with identification.

Washman

[Washman]

Re: Electrolux EOB5600B oven not heating yet grill works fin

Hi

Have you checked the round oven element at the back by the fan .

Washman

[Washman]

Re: Clamp Meter info required please..

Hi

I have always used a clamp meter, to check when heater/elements are energised. Also if motors are drawing to much current.
Just check heater for continuity as usual then place clamp over one wire to heater and read amps, you can then tell when heater switches on/off without need to use probes on multimeter to read voltage. Multimeter only tells you if voltage is at the heater not if the it is working.

Mike

[Washman]

Re: Hotpoint 1200 De Luxe 9549

Hi

Live testing should never be attempted,a multimeter should be used.
And motors are designed to be controled by the electronic board ,so should never be connected directly to mains voltage.

Washman

[Washman]

Re: zanussi zwd147s tub seal seems an odd one

Hi

The groove is formed when the 2 halves of the tub are screwed toogether,

Washman

[Author]

Posts