[Washman]

Re: Bosch Wae24470gb/08

Hi

Try this from Martin I think . Bosch WAE24162
To reset it.
Turn the appliance knob to the off or reset position, 12 o’clock.
Turn the knob to the 6 o’clock position.
Press and hold the spin button.
Whilst holding it, turn the knob to the 7 o’clock position.
Continue holding the spin button for about 5 seconds.
Release the button.
Turn the knob to off.
When your turn it back on it should have cleared the error code.
Hope that helps.
Mike

[Washman]

Re: Cooker Hood – Luxair – Lights not working

Hi

You need to ring Luxair UK on 01765641888 for spares.

Washman

[Washman]

Re: Samsung B1415J showing error code EA not listed in manua

Hi

“EA” is a motor fault, Motor defect open/short ciruit windings,loose connector , PCB fault.

Check armature ~2ohms
Windings ~1.5
Tacho ~40 ohms
Protector ~0 ohms

Power off and plug out before working on machine.

Washman

[Washman]

Re: Indesit DI620

Hi

I noticed on your first post you say you put table salt into salt container, this is the wrong type of salt it has to be dishwasher salt. Table salt will probably set into a hard lump and should not be used in a dishwasher. So you need to remove the table salt as soon as posible.

Washman

[Washman]

Re: Diplomat ADP4520 main oven element, removal problem

Hi

You need to remove the oven from the housing and take the back off to get at the nuts that hold the element in place. It cannot be done from inside oven.they are fixed bolts on the element.

Power off first before any panels are removed.

Washman

[Washman]

Re: Masterpart, Do they wont orders

Hi

If you have an account with them go to the home page put in your E-mail address and password as “masterpart” in lower case without the “” . Then go to my account and change the password to your own, everything should work

Mike

[Washman]

Re: KUPPERSBUSCH DISHWASHER IGV 658.1

Hi

“H” in display is water heater problem according to service manual.

Mike

[Washman]

Re: HVR HED6612-80 service manual

Hi

E mail address mike-turnerATtalktalk.net

TIA Mike

[Washman]

Re: Hotpoint VTD00 wiring diagram

Hi Jim

Thanks for the manual very helpfull

Mike

[Washman]

Re: Hotpoint VTD00 wiring diagram

Hi

mike-turnerATtalktalk.net

Mike

[Washman]

Re: TEKA A-LF12 ??

Hi

On Teka site it shows as ALS 12 looks a bit like a Candy washer dryer

Mike

[Washman]

Re: Creda cond dryer 37747 plug terminals very hot

Hi

Have you checked the socket.

Mike

[Washman]

Re: Candy CSD68-80 Heater

Hi Don

Thanks

That part no is Ok on Connect, I just put HVR in front and it found it.

Mike

[Washman]

Re: Bosch SGS5342 GB/17 will not fill with water.

Hi

2H means that you have the time delay set,just cancel delay time.

2H = 2 hour delay before machine will start.

Washman

[Washman]

Re: service rain wave 1100 easher dryer

Hi

This is a 6 year old post so I dought Sheppy is watching this forum .The answer to you question is in post above.

Washman

[Author]

Posts