Forum Replies Created
-
Posts
-
Re: Neff 4381X1GB/01
Thank you for that Kentish. It is just over thirteen years old. PCB was my second guess. I will hope it is no more than a dry joint when I go back. Thank you again. Steve.
Re: Hoover Vision DYN9144
Thanks fellas. This machine is outside in a stable, so very possible that you are correct. I’ll check it out. Steve.
Re: samsung WD8704 pump problem
I’m sure you will be aware, but just in case, I went to one of these, not sure if it was the same model, but there is a switch on the filter door. Steve.
Re: Hotpoint BHWM149
Hi, I know I said all, but the progress lights don’t flash, just the horizontal programme lights. Sorry for misleading. PCB was my thought also.
Re: Whirlpool AZB 7470 Tumble Dryer
Aha, that makes sense Dave. This dryer was in a small shower room, probably used with the door shut then.
Cheers
Steve.Re: Whirlpool AZB 7470 Tumble Dryer
Cheers for that Dave. Do you know what the cause of the problem is? I couldn’t find anything obviously wrong, but was beginning to suspect the dreaded NTC fault. I will try your suggestion and let you know. Steve.
Re: AEG F89020VI
Hey up Dave. Yes, I checked the relay for dry joints but any info is useful ta. I will pm you my email address. cheers. Steve.
Re: Beko WMB81445LW
Cheers Dave. The manual would be appreciated, but there are no numbers relating to the ones you have given. The rating plate shows the following : Model no as shown. 5023790. 028318.
DOK XL 2879501900. Thank you. Steve.Re: AEG F89020VI
Yes Dave, I have checked the heater relay visually, and it is ok. The NTC is a type I haven’t seen before, but it could be switching early I suppose. The price of the board makes the NTC an avenue worth taking. Thank you for your reply. I’ll let you know how it goes. Cheers. Steve,
Re: wmb71442s none starter
Interlock? Interlock connections? If not it looks as if it could be modular.
Steve.Ah, just seen your second post. Must be an askoll 🙂
Re: HJA 8703
Before I had chance to go back, the customer rang to say it was working. Miracles DO happen. Cheers fellas. Steve.
Re: ZWD14270W1
Dryer heater checked out ok. I think it must be the power supply. Thank you for your help fellas. Steve.
Re: HJA 8703
I checked this out, and it is all clear. I guess I’m looking at a bit of a strip down job to sort this one . . . . . . . unless someone knows differently 🙂 . Cheers. Steve.
