Forum Replies Created
-
Posts
-
Re: Zanussi IZ12 Washer E90 fault
ribbon cable between the boards pull it off wipe the contacts put it back on usually works
wilf
Re: Is it me OR I’m missing something
coulnt live without my vax have a special slot for it on the van makes life so much easier plus I dont have to kneel in the wet
wilf
Re: best way get into zanussi wm tub w/ middle split body pa
Im with Madmac keep it upright two bits of wire through the springs pull up then lower it down easy!!!!!!!!!
wilf
Re: Ancient Zan FL1012 rinse fault
what resistance have you got asross the valve? try a valve first cheapest line to check
wilf
Re: gone dead
last week was the only good week in febuary if there is any money about customers are hanging on to it the only comfort is that it seems very much across the board and not some mistake I’m making
wilf
P.S. just mended the roof on the chicken house new chickes due soon light sussex if I can get them.
Re: Yellow Pages
the wrong phone number thing caught me out yell told me that they would analise my calls and give me a breakdown. sounds fine. but when I looked at my ad wow! whats that strange number? it appears that it is used to pass my calls through some sort of counting device I rang and got MY number put in place ( I dont think I was the first to complain) whats the point of having your number printed on cards bills flyers vans only for some #### to change it through some device without a by your leave? 😯
not pleased
wilfRe: wheres the work gone?
still no up turn in sight never known it so quiet for days on end like this. what I cant work out is why the abrupt stop? plodding along sort of average then………….well ….brakes on!
wilf 😕
Re: WD440 fault…might be helpful
I,ve got one took out one shot stat took apart clean out fit new normal tests all ok stat lasted one wash NTC reads 28K but only now displaying error code 12&4 I did once have an NTC fail mechanically (fell to pieces) and on ordering one to try, I see that the part number has been changed could there be a known fault with these that is intermittant?
wilf
Re: White Knight tumble dryers
I’ve tried refitting one before but not a great success as the worn holes even when drilled out and fitted with washers and bolts allowed early failure (2-3 months) it would seem thet the spider MUST be specially rivited with those stainless rivets. if the metal was a bit thicker I might have had more sucess or the thing might not have failed in the first place.
wilf
