Forum Replies Created
-
Posts
-
Re: work dead
very quiet here they all ask how much rather than how quick these days having a job to create orders big enouhg for free delivery
hope it improves
wilf
Re: hoover CA232
says on the front CA232 and it does have a handle 41009227 fitted
dont ask me why what or how but if anyone comes across this again this fits
wilf
Re: AEG 72640 washer
I did crimp the edge connectors but I didnt take the boad off I’ll have another look
thanks wilf
Re: WD61 cabinet by suspa leg cracked.
dont think so. hasnt the later cabinet got more webs pressed into it for strength ? you might be able to cut and bolt the bracket to fit take a saw a drill and some large pop rivits with you nothing to loose.
wilr
Re: work dead
yes, last week as well but looking back these weeks were very quiet this time last year.
wilf
Re: statistics ???
no parts fitted for me 50.19{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} this does include BER but quite often I will not charge for something that costs me less than a quid or so eg rear spring on a Wm52 if it takes less than a few seconds to fit. am I a fool or does this look good to the customer? cheap word of mouth advertising for me
wilf
Re: hotpoint wf740 not responding to switching on
check the switches on the display board then look for worn carbons
wilf
Re: HPT new belt fitting tool
both sides and back off capacitor off (hanging on the wires) drum out. fit belt onto shaft then feed drum into the belt to the side of the machine ensure that the belt is sitting on the line made by the old belt then roll the drum into place over the motor with the belt sitting correctly on the jockey pulley. fit the drum onto the front guides. refit the back then lever the rear of the drum up and into the rear bearing (a screwdriver in a rear perferation leavering against the heat appeture helps)
reassemble
sorted!!!!!!!!!!
wilf 🙂
Re: Hotpoint WD420P Leak
it seems that “some” leak I had one try as I might adjusting the pressure cleaning etc it still leaked in the end I fitted a new dispenser same pattern but it cured the leak!!!!!!!!!!
do you remember the old hoover softwave used to have a similar problem but that was cured by pulling the draw out half an inch.
wilf
