Forum Replies Created
-
Posts
-
Re: HOTPOINT WD440P
have you checked the display board to see that the minature switches are intact?
wilf
Re: How to seperate sealled Drum
stripping a tub apart and knocking bearings and changing spider is hard work but just to pull one unit out and put in another thats a different matter. I know most of my customers would proberbly balk at prices much over £125 all in. when it comes to it and I’m confronted with a sealed tub change I’ll see what happens. what I dont want to do though is to get involved with disposal of old tubs this could push the costs to BER.
wilf
Re: How to seperate sealled Drum
when times are hard it,s 40 quid in your pocket or nothing. it’s a pretty simple job so I think I’d proberbly take the 40 quid.
wilf
Re: hotpoint wt 540
been to it today yep! its the valve funny error code though just prewash flashing
thanks everyone
wilf
Re: wf250
I find that quite often the problem is initally caused by sticky drinks etc being spilt and running off a worktop and down the machine . a wipe only cleans the front and the buttons jamb requiring a firmer push and with such “robust” construction component failure is the result.
zanussi knobs suffered the same troublewilf
Re: Indesit WIA111(UK) Door lock light keeps flashing
seems to be a common fault, board gone EMW do them
wilf
Re: no work
so where’s all the customers gone? one job today and the phone hasnt rung with any real work all day.
green shoots ….what green shoots?wilf
Re: whirlpool AKZ451 X 01 oven
looks like its a no go then.
what ever was wrong with a good thermostat?????????wilf
Re: Stuck bearings…
dremel cut off disc will with grind through at an angle but you will need some care or a lot of discs.
its worked for me lots of times.wilf
Re: neff oven elements
when I can I’m now fitting connect ELE9036 if I can, its 2300watt but costs over twice as much but seem much more reliable so no call backs………….yet! the extra cost is worth it as far as I’m concerned as it keeps the customer happy and is an easy profitable little job.
wilf
Re: beko WMA1715
chris Ive looked at the disc and found some codes 🙂 (I hate acrobat reader 😡 ) which Ive put on known errors still think its board as machine wont do anything but flash prewash. EMW list this as common fault
wilf
Re: Known Error Codes
beko WMA1715
turn machine off select 90 deg cotton press and hold start, switch on keep holding start for three secs it will then flash
turn knob to spin press start light codes as follows
prewash ……………………………. NTC
main wash …………………………..no heat
prewash and main wash………….. constant heat
rinse………………………………….. no fill
prewash and rinse ………………….no drain
prewash main wash and rinse……. pressure switch
main wash and rinse ………………. tacho/ pcb
rinse and cond ………………………. no motor actionto reset error codes hold start for five secs
wilf
