admin

Forum Replies Created

Viewing 15 posts - 316 through 330 (of 12,518 total)
  • Author
    Posts
  • in reply to: New Fridge Freezer Miele Worth it? #441222
    admin
    Keymaster

    Re: New Fridge Freezer Miele Worth it?

    Hi

    Miele or Liebherr they are the same other than cosmetic. Miele come off the same production line and use the same components.

    They would be my choice to buy.

    Bryan

    in reply to: Hoover vision HD 1400 AAA washing machine #441213
    admin
    Keymaster

    Re: Hoover vision HD 1400 AAA washing machine

    Hi

    Change the water heating element.

    Bryan

    in reply to: Daewoo American FFs no plumbing required #441065
    admin
    Keymaster

    Re: Daewoo American FFs no plumbing required

    Hi

    There will be a refillable water tank inside the fridge section normally on the fridge door and this would normally hold about 1-2 ptrs.

    Bryan

    in reply to: RangeMaster sxs fridge/freezer problems with temp #441036
    admin
    Keymaster

    Re: RangeMaster sxs fridge/freezer problems with temp

    Hi

    I doubt very much if the repair that was to the water pipework caused this. The easiest way to start is to defrost the whole unit for a min of 24hrs with both the doors open and switched off at the plug. Then restart and if it works and goes down to the correct temp great but if it stops cooling correctly normally after a few days then it’s pointing towards the defrost cycle and or fan.

    Bryan

    in reply to: Rosieres 4040 DB “Paul Bocuse” Door hinge runners #440994
    admin
    Keymaster

    Re: Rosieres 4040 DB "Paul Bocuse" Door hinge runners

    Hi Paul

    Replace the hinges with the hinge receivers or your’ll be back in the same position shorter than you’ll like. We always change both as a set.

    Bryan

    in reply to: fridge bulb #438801
    admin
    Keymaster

    Re: fridge bulb

    Hi

    Be careful as most of the Fridgemaster ones used a 10w slim bulb and using the standard one will melt the lens/cover.

    Bryan

    in reply to: Samsung RSH1NHMH Fitting a new heater #440950
    admin
    Keymaster

    Re: Samsung RSH1NHMH Fitting a new heater

    Hi

    Those 2 arrow heads clip onto the bottom of the heater. Then onto the bottom of the evaperator.The botch up silver foil covers up the crappy plastic liner that the old heater that was too powerful burnt. One clip one way the other the opposite direction.

    Bryan

    in reply to: Belling Cooker – Almost a fire – new Loom? #440943
    admin
    Keymaster

    Re: Belling Cooker – Almost a fire – new Loom?

    Hi

    More likely that the mains cable hasn’t been tightened enough. Butt connect the wiring with new wiring.Not a problem if you use the correct crimping pliers and I don’t mean those cheap chinese that buckle when ever theres pressure put on them.

    Bryan

    in reply to: Zanussi RW 801 Bits of putty like substance on clothes #440893
    admin
    Keymaster

    Re: Zanussi RW 801 Bits of putty like substance on clothes

    kwatt,
    Many thanks for parts pdf, are hoses and the like available please?
    imk

    in reply to: Zanussi RW 801 Bits of putty like substance on clothes #440890
    admin
    Keymaster

    Re: Zanussi RW 801 Bits of putty like substance on clothes

    aqualectric many thanks for your reply.

    I used persil powder for years and normally use Fast Coloured wash for both coloured and whites and Woollens for wool. However this last box of powered I bought was Fairy non Bio so maybe it is it. Although after starting this thread I checked the door seal and some gunge had accumulated in the folds so I cleaned it all up and it does not look like it is disintegrating. Also I removed the detergent draw and gave it a good clean. But looking inside the hose that leads from detergent draw to drum looks bit manky so wonder if it is that that is failing.
    I found on ebay a door seal but could not find the hose from detergent draw to drum, any ideas where I can find one please as seems a shame to dump the machine as still does a wash or two a week, maybe time for major service 🙂
    Been a rock solid washer as done four house moves and two wives.
    again many thanks imk

    in reply to: URGENT HELP NEEDED: Samsung rs20ccsv #350418
    admin
    Keymaster

    Re: URGENT HELP NEEDED: Samsung rs20ccsv

    Hi

    Read and carry out the above posts before requesting more help

    Bryan

    in reply to: engineers please help..Hoover HDC884X oven thermostat switch #440717
    admin
    Keymaster

    Re: engineers please help..Hoover HDC884X oven thermostat sw

    Hi

    The wiring diagram and schematics have been supplied with comes directly from Hoover /Candy.

    You need to follow the wiring to the different component parts and trace from there.

    The information that you have is more than the majority of engineers have. If you can’t read or follow them then you will need to get an engineer to follow the diagrams.

    Bryan

    in reply to: hoover dyn9164dpg #440787
    admin
    Keymaster

    Re: hoover dyn9164dpg

    Check the air tube and bottle then as it’s not normally a problem other than showing E16 E3 and that is the heater even though they still heat up.

    Bryan

    in reply to: Hoover DXP48AIW3 #440791
    admin
    Keymaster

    Re: Hoover DXP48AIW3

    Hi Tim

    No high level failures and no tech bulletins. Whats the fault ?

    Bryan

    in reply to: hoover dyn9164dpg #440783
    admin
    Keymaster

    Re: hoover dyn9164dpg

    Element

    Bryan

Viewing 15 posts - 316 through 330 (of 12,518 total)